User manual WHIRLPOOL TEST 2809 PRODUCT FICHE

[. . . ] € The device must not be pressed for more than 15 sec. If, after that time has elapsed, the burner does not remain lit, wait at least one minute before trying to light it again. - The burner might go out when the knob is released. This means that the thermocouple has not warmed up enough. [. . . ] Warnings: if the glass ceramic surface should break or crack, refrain from using it and call the After-sales Service immediately. Any repairs or maintenance work on the appliance must be carried out exclusively by a qualified technician. Never touch the cooktop with any wet part of the body and do not operate it with bare feet. € Always keep a watch on pans when cooking with oil and grease. Oil and fat can overheat and catch fire!€ Do not use the glass ceramic hob as a work surface or support surface. € Do not switch on the electric hotplate without pots. € Do not place plastic, aluminium foil, cloths, paper etc. On the cooking zone while it is still hot. € NOTES: Improper use of the grids can result in damage to the hob surface. Do not position the grids upside down or drag them across the hob. By ensuring that this appliance is scrapped suitably, the user can help prevent potentially damaging consequences for the • environment and health. The symbol on the product, or on the documents accompanying the product, indicates that this appliance may not be treated as household waste. Instead, it must be delivered to an appropriate collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For more detailed information about treatment, recovery and recycling of this product, please contact your local authority, household waste disposal service or the shop where you purchased the product. - a) b) c) d) INSTALLATION GAS CONNECTION • • • • The gas supply system must comply with local regulations. You can find specific local regulations for some countries in the paragraph “Relevant National Regulations. If no information concerning your Country is given, please ask your installer for details. The connection of the hob to the gas pipe network or gas cylinder must be made by means of a rigid copper or steel pipe with fittings complying with local regulations, or by means of a continuous-surface stainless steel hose complying with local regulations. The maximum length of the hose is 2 linear metres. Before connecting the tube to the elbow fitting (A), insert the washer (B) supplied in between the two, in compliance with EN 549. [. . . ] The earthing of this appliance is compulsory by law. L Earth (yellow/green) N Should you experience difficulty in turning the burner knobs, please contact the After Sales Service for the replacement of the burner tap if found to be faulty. REPLACING THE INJECTORS (see the injector table in the Product Description Sheet) Remove grids (A) Extract burners (B) Using a socket spanner of the appropriate size, unscrew the injector (C) • Replace it with the injector suitable for the new type of gas. Before installing the hob, remember to affix the gas calibration plate supplied with the injectors in such a way that it covers the existing information relating to gas calibration. [. . . ]