User manual WHIRLPOOL TGW 5575 IN PROGRAM CHART

[. . . ] The burner might go out when the knob is released. This means that the thermocouple has not warmed up enough. In this case, repeat the operations described above. • - NOTE: PRATICAL ADVICE FOR USING THE BURNERS For better burner performance, please stick to the following rules: Use pots and pans that fit the burners (see table on the right). [. . . ] In the case of pans with convex bottoms (WOK), use the support grille provided, which should be positioned only on the 4 ring burner. Burner 4 ring Rapid semi-rapid auxiliary Pot Ø from 24 to 26 cm from 24 to 26 cm from 16 to 22 cm from 8 to 14 cm If the distance “A” between the wall cabinets is between 600 mm and 730 mm, the height “B” must be a minimum of 520 mm. If the distance “A” between the wall cabinets is greater than the width of the cooktop, the height “B” must be a minimum of 400 mm. In case of installation of a hood above the cooktop, please refer to the hood instructions for the correct distance. CATEGORY II2E+3+ Type of burner Ø injector Rated thermal flow rate kW 3. 50 3. 00 1. 65 1. 00 3. 50 3. 00 1. 65 1. 00 3. 50 3. 00 1. 65 1. 00 Rated consumption 333 l/h 286 l/h 157 l/h 95 l/h 254 g/h 218 g/h 120 g/h 73 g/h 250 g/h 214 g/h 118 g/h 71 g/h Total rated consumption 1028 l/h 785 g/h 771 g/h Reduced heat capacity kW 1. 95 0. 80 0. 45 0. 35 1. 50 0. 60 0. 35 0. 30 1. 50 0. 60 0. 35 0. 30 Gas pressure (mbar) min. max. INJECTOR TABLE Type of gas used NATURAL GAS (Methane) G20 4 ring Rapid Semi-rapid Auxiliary 4 ring Rapid Semi-rapid Auxiliary 4 ring Rapid Semi-rapid Auxiliary Configuration model 5 burners 5 burners 5 burners 139 128 95 78 95 87 67 50 95 87 67 50 Rated thermal flow rate kW 10. 8 10. 8 10. 8 17 20 25 LIQUID PETROLEUM GAS (Butane) G30 20 28-30 35 LIQUID PETROLEUM GAS (Propane) Type of gas used G20 20 mbar G30 28-30 mbar G31 37 mbar G31 25 37 45 Air necessary (m3) for the combustion of 1 m3 of gas 9. 52 30. 94 23. 80 ELECTRIC SUPPLY: 230 V - 50 Hz 5019 419 60261/A To get full satisfaction from the hob, please read these instructions carefully and keep them for future consultation. PRECAUTIONS AND GENERAL ADVICE To get full satisfaction from your hob, please read these instructions carefully and keep them for future consultation NOTES: • • • • • • • These instructions are only valid for those Countries where the destination abbreviations are mentioned on the product description sheet and on the hob. Keep the packaging material (plastic bags, polystyrene parts, etc. ) out of the reach of children, as they are potentially dangerous. Check whether the hob has been damaged during transport and remove any protective film from the appliance parts. This hob (Class 3) is designed solely for household use for cooking food. Any other use (such as heating rooms) is to be considered improper and, as a consequence, dangerous. If there is no oven beneath the hob, insert a separator panel that has a surface at least equal to the opening in the work surface. This panel must be positioned at a maximum distance of 150 mm below the upper surface of the work surface but, in no case less than 20 mm from the bottom of the hob. In the case that you intend to install an oven beneath the hob, make sure that it is manufactured by Whirlpool and equipped with a cooling system. The manufacturer declines all liability if another brand oven is installed beneath the hob. Before installation, make sure that: the local gas delivery conditions (nature and pressure) are compatible with the settings of the hob (see the rating plate and injector table). The outer surfaces of the furniture or appliances adjacent to the hob are heat resistant according to local regulations. Combustion products are discharged outdoors through specific hoods or wall and/or window mounted electrical fans. Continuous natural air circulation is ensured through a clear opening in a wall of at least 100 cm2. This wall opening must be: permanent and in a wall to the outside of the room to be vented; made in such a way that it cannot be obstructed from the inside or outside (not even accidentally); protected by plastic grids, metallic mesh, etc. , taking care not to reduce the air vent effective area mentioned above; located near floor level and positioned so as not to interfere with the operation of the exhaust system. PROTECTING THE ENVIRONMENT 1. [. . . ] This wall opening must be: permanent and in a wall to the outside of the room to be vented; made in such a way that it cannot be obstructed from the inside or outside (not even accidentally); protected by plastic grids, metallic mesh, etc. , taking care not to reduce the air vent effective area mentioned above; located near floor level and positioned so as not to interfere with the operation of the exhaust system. PROTECTING THE ENVIRONMENT 1. Packaging The packaging material is entirely recyclable, and is marked with the recycling symbol , which identifies it as a type of material that must be sent to local waste-disposal centres. Product This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). [. . . ]