User manual WHIRLPOOL TGW 5576/PT INSTRUCTION FOR USE

[. . . ] This burner safety device shuts off the gas supply to the burner if the flame goes out accidentally (because of sudden draught, an interruption in the gas delivery, boiling over of liquids, etc. ). The device must not be pressed for more than 15 sec. If, after that time has elapsed, the burner does not remain lit, wait at least one minute before trying to light it again. [. . . ] Any other use (such as heating rooms) is to be considered improper and, as a consequence, dangerous. Ensure that the installation and gas/electrical connections are performed by a qualified technician in compliance with current local safety regulations. This appliance should only be installed and used in well-ventilated rooms, in accordance with current regulations. Carefully read the instructions before installing and using this appliance. Gas adjustment and supply pressure are indicated on the rating plate located under the hob. If the appliance is arranged for a type of gas different from that available, refer to the paragraph “Ajustment to different types of gas”. Improper use of the grids can result in damage to the hob surface. Do not position the grids upside down or drag them across the hob. • If the hob has a glass ceramic top, do not use: - Cast iron griddles or terracotta pots and pans - Heat diffusers (e. g. metallic mesh) - Two cookers for the same pot • In case of prolonged use, additional ventilation may be needed (opening a window or increasing the extraction force of the hood). • Keep children away from the hob when it is in use and do not let them play with the controls or any other appliance parts. Warning: the protective rubber feet on the grids represent a chocking hazard for young children. After removing the grids, please ensure that all the feet are correctly fitted. Attention: the glass lid (if provided) may shatter if overheated. Before closing it, make sure that all the burners are off. • After use, make sure that the knobs are in position OFF and close the main gas delivery or cylinder tap • REFERENCE TO LOCAL REGULATIONS BE The appliance is supplied with a 1/2’’ threaded conical end to be connected to the gas supply (according to ISO regulations ISO 7/1 RP 1/2). The connection must be effected in accordance with standard NBN D 51-003 using rigid piping or in accordance with specifications sheet A. R. G. B. /03 using flexible tubing. The appliance must be installed complete with an AGB-approved stop valve. INSTALLATION TECHNICAL INFORMATION FOR THE INSTALLER • • This product can be embedded in a worktop 20 to 40 mm thick. If there is no oven beneath the hob, insert a separator panel that has a surface at least equal to the opening in the work surface. [. . . ] By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The symbol on the product, or on the documents accompanying the product, indicates that this appliance may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. [. . . ]