User manual WHIRLPOOL TGW 5595 IN PROGRAM CHART

[. . . ] Position the brackets in the holes and tighten with the screws supplied. Install the cooktop into the worktop. • • • • • Electrical connection Installation must be carried out in compliance with the regulations of the local electricity supply company. Make sure that the voltage indicated on the rating plate corresponds to the voltage in your home. Regulations require that the appliance is earthed: use conductors (including the earth conductor) of the appropriate size only. [. . . ] with little water in order to cut down cooking time. A pressure cooker allows you to save even more energy and time. • 15 4gb66005. fm5 Page 16 Monday, January 28, 2002 5:04 PM Protecting the environment 1. Packing • The packaging material can be 100% recycled, as confirmed by the recycling symbol ( ). Products • The appliances are built from recyclable materials. If you decide to scrap the appliances act responsibly and observe local waste disposal by laws. Cut off the power cords so that the appliances cannot be connected to the mains. • The appliances (Class 3) are designed solely for use as cooking appliances. for room heating) is considered as improper use and potentially dangerous. The appliances are designed, built and sold in compliance with: Gas safety requirements 90/396/CEE. The safety requirements of “Low Voltage” Directive 73/23/EEC. The protection requirements of EMC Directive 89/336/EEC. In these remains are allowed to affect the surface over a period of time, they can cause discoloration. Note: The high temperatures of the flames, may affect, in a long term use, the colour the surface around the burners. Cleaning the burners 1. Soak the cap in hot water and liquid detergent. Ensure that none of its opening is clogged. Note: To avoid damaging the electric ignition device, do not use it when the burners are not in place. Troubleshooting Guide 1. The burner does not work: • Is the main gas cylinder valve open?• Has the delivery of the gas been suspended?• Are the openings of the burner clogged?• Have the cap and burner been positioned correctly after cleaning?The burner fails to remain lit: • Repeat the ignition operation, turning the knob to the position with the small flame symbol. The electric ignition device does not work: • Is there a power failure? 17 4gb66005. fm5 Page 18 Monday, January 28, 2002 5:04 PM After Sales Service Before contacting After Sales Service 1. [. . . ] Connection to gas supply The connection to the gas pipe network or gas cylinder must be made with a rigid copper or steel pipe with fittings complying with standards UNI 7129 or with continuous surface stainless steel hose complying with standards UNI 9891. length of the hose is 2 m. 18 4gb66005. fm5 Page 19 Monday, January 28, 2002 5:04 PM U. K. Provision for ventilation The room containing this appliance should have an air supply in accordance with the current B. S. All rooms require a permanent vent in addition to the openable window. [. . . ]