User manual WHIRLPOOL TGW 5595/PT INSTRUCTION FOR USE

[. . . ] overheated oils and fats catch fire easily. Always remain vigilant when cooking foods rich in fat, oil or alcohol (e. Keep the packaging materials out of the reach of children. Before cleaning or maintenance wait for hob to cool down. [. . . ] - Do not pull the power supply cord in order to unplug the appliance. - The electrical components must not be accessible to the user after installation. - Do not touch the appliance with any wet part of the body and do not operate it when barefoot. - This hob (class 3) is designed solely for private household use for cooking food. Do not use this appliance as a space heater to heat or warm the room. Doing so may result in carbon monoxide poisoning and overheating of the hob. The Manufacturer declines all responsibility for inappropriate use or incorrect setting of the controls. - The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or with lack of experience and knowledge of the appliance, unless supervised or previously instructed in its use by those responsible for their safety. - Young children should be kept away from the appliance and supervised to ensure that they do not play with it. gAS CONNECTION WARNING • • This operation must be performed by a qualified technician. The gas supply system must comply with local regulations. €¢ The primary air of the burners does not need to be adjusted. €¢ 40 Position the hob in the worktop opening made respecting the dimensions indicated in the Instruction. NOTE: the power supply cable must be long enough to permit its upward extraction. To secure the hob, use the brackets (A) provided with it. Fit the brackets into the relevant bores shown by the arrow and fasten them by means of their screws in accordance with the thickness of the worktop (see the following figures). Top 20 mm 20 Top 40 mm At this stage, light up the burners and turn the knobs from max position to minimum position to check flame stability. Upon completion of adjustment, reseal using sealing wax or an equivalent material. REFERENCE TO LOCAL REGULATIONS Top 30 mm 30 60 Top 60 mm Installation must be performed in accordance with standard NBN D 51-003. AFTER-SALES SERVICE Before calling the After-Sales Service, make sure you can give the following information: - type of fault or problem; - exact model (written on the label affixed to the instruction/warranty); - service number that follows the word SERVICE on the rating plate under the hob and on the label affixed to instruction/warranty; - your complete address and phone number. If any repairs are required, please contact an authorised After-Sales Service, as indicated in the warranty. aDJUSTMENT TO DIFFERENT TYPES OF GAS WARNING This operation must be performed by a qualified technician. [. . . ] The containers are not stable Check that: • The bottom of the container is perfectly flat • The container is centered on the burner. • The grids have not been exchanged or positioned incorrectly. If after the above checks the fault still occurs, get in touch with the nearest After Sales Service. €¢ DECLARATION OF CONFORMITY This hob has been designed, constructed and marketed in compliance with: - safety requirements of “Gas” Directive 2009/142/EC (ex: EEC 90/396); - safety objectives of the “Low Voltage” Directive 2006/95/EC (which replaces 73/23/EEC and subsequent amendments); - protection requirements of EEC Directive “EMC” 2004/108/EC. [. . . ]