User manual WHIRLPOOL TGZ 3405 SW PROGRAM CHART

[. . . ] The burner might go out when the knob is released. This means that the thermocouple has not warmed up enough. In this case, repeat the operations described above. NOTE: In case of installation of a hood above the cooktop, please refer to the hood instructions for the correct distance. [. . . ] max. PRATICAL ADVICE FOR USING THE BURNERS For better burner performance, please stick to the following rules: Use pots and pans that fit the burners (see table on the right). Use the correct amount of water for cooking foods and keep the pot covered. Burner ultra-rapid semi-rapid auxiliary Pot Ø from 24 to 26 cm from 16 to 22 cm from 8 to 14 cm NATURAL GAS (Methane) G20 17 20 25 LIQUID PETROLEUM GAS (Butane) G30 LIQUID PETROLEUM GAS (Propane) G31 Type of gas used G20 20 mbar G30 28-30 mbar G31 37 mbar 20 28-30 35 25 37 45 Configuration model 4 burners 4 burners 4 burners Rated thermal flow rate kW 7. 80 7. 80 7. 80 Air necessary (m3) for the combustion of 1 m3 of gas 9. 52 30. 94 23. 80 ELECTRIC SUPPLY: 230 V ~ 50 Hz 5019 419 01128 To get full satisfaction from the hob, please read these instructions carefully and keep them for future consultation. PRECAUTIONS AND GENERAL ADVICE To get full satisfaction from your hob, please read these instructions carefully and keep them for future consultation Declaration of conformity • This hob has been designed, constructed and marketed in compliance with: - safety requirements of EEC “Gas” Directive 90/396; - safety objectives of the “Low Voltage” Directive 2006/95/CE (which replaces 73/23/CEE and subsequent amendments); - protection requirements of EEC “EMC” Directive 2004/108/EC; - requirements of EEC Directive 93/68. This hob is suitable for contact with foodstuffs and complies with EEC (CE) Regulation n. 1935/2004. • • • • • • • These instructions are only valid for those Countries where the destination abbreviations are mentioned on the product description sheet and on the hob. Keep the packaging material (plastic bags, polystyrene parts, etc. ) out of the reach of children, as they are potentially dangerous. Check whether the hob has been damaged during transport and remove any protective film from the appliance parts. This hob (Class 3) is designed solely for household use for cooking food. Any other use (such as heating rooms) is to be considered improper and, as a consequence, dangerous. After use, make sure that the knobs are in position OFF and close the main gas delivery or cylinder tap INSTALLATION TECHNICAL INFORMATION FOR THE INSTALLER • • This product can be embedded in a worktop 20 to 40 mm thick. If there is no oven beneath the hob, insert a separator panel that has a surface at least equal to the opening in the work surface. This panel must be positioned at a maximum distance of 150 mm below the upper surface of the work surface but, in no case less than 20 mm from the bottom of the hob. In the case that you intend to install an oven beneath the hob, make sure that it is manufactured by Whirlpool and equipped with a cooling system. The manufacturer declines all liability if another brand oven is installed beneath the hob. Before installation, make sure that: the local gas delivery conditions (nature and pressure) are compatible with the settings of the hob (see the rating plate and injector table). The outer surfaces of the furniture or appliances adjacent to the hob are heat resistant according to local regulations. Combustion products are discharged outdoors through specific hoods or wall and/or window mounted electrical fans. Continuous natural air circulation is ensured through a clear opening in a wall of at least 100 cm2. [. . . ] This wall opening must be: permanent and in a wall to the outside of the room to be vented; made in such a way that it cannot be obstructed from the inside or outside (not even accidentally); protected by plastic grids, metallic mesh, etc. , taking care not to reduce the air vent effective area mentioned above; located near floor level and positioned so as not to interfere with the operation of the exhaust system. PROTECTING THE ENVIRONMENT 1. Packaging The packaging material is entirely recyclable, and is marked with the recycling symbol , which identifies it as a type of material that must be sent to local waste-disposal centres. Product • This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). [. . . ]