User manual WHIRLPOOL TK PLUS 72A DI PROGRAM CHART

[. . . ] The indicator lamp above the relevant button lights up to confirm your selection. A fast blinking led indicates a wrong selection is made (incompatible options). Press the button again to cancel the option. The drying programme is started by pressing the “Start (Pause)” button. [. . . ] • Was the inserted laundry too wet (washing machine spin speed less than 1000 rpm)?• Is the door filter dirty (filter indicator light on)?• Is the bottom filter dirty (for more information, refer to the instructions for use)?• Is the room temperature too high?• Are the “End” and “Anticrease” indicator lamps lighting up?The drying cycle is complete and the laundry can be taken out. • If the drying result does not meet your expectation, select a drier programme. You can use the dryness adjustment option (if available) to optimize the drying results. • • • • • • • • • • • • • • • • • Is the plug properly inserted into the mains electricity socket?Has the “Start (Pause)” button been pressed?Has the start delay option been selected?Has the water container been inserted correctly?Is the bottom filter clean and inserted correctly?Has the bottom filter been inserted correctly?Have all lint on the bottom filter seal and the door seal been wiped away?Has the water container been inserted correctly?If the direct drain connection is used, is it tight?Is the dryer levelled? Drying takes too long/ Laundry is not dry enough The dryer does not operate (after a power failure, always press the “Start (Pause)” button) Door filter, water container or bottom filter indicator lamp on Water droplets underneath the dryer . . . you want to care of and clean your dryer: • Brush lint using a soft brush or your fingertips. • Pull the handle to remove the water container. • Replace the water container when empty by pushing it completely back in place. • Clean the bottom filter under running water. • Remove all fluffs from the seals. [. . . ] The drying cycle is automatically interrupted. Empty the container and restart the drying program. Empty the water container after every drying cycle. Key lock For child protection reasons, this option can be used to lock all functions of the user interface. To activate/deactivate this option, the button needs to be pressed for 3 seconds. [. . . ]