User manual WHIRLPOOL TOP 4140 INSTRUCTION FOR USE

[. . . ] After unpacking the appliance, make sure that the door shuts properly. Any damage must be reported to your dealer within 24 hours after delivery of the appliance. Wait at least two hours before connecting the appliance to the power supply in order to ensure the refrigerant circuit is fully efficient. Installation of the appliance and electrical connections must be carried out by a qualified electrician, in accordance with the manufacturer's instructions and local regulations. • • • • SAFEGUARDING THE ENVIRONMENT 1. [. . . ] • Do not place hot food in the refrigerator. • Store liquids in closed containers. 13 6gb33012. fm5 Page 14 Thursday, February 8, 2001 5:47 PM HOW TO DEFROST THE REFRIGERATOR Defrost the appliance when the ice on the walls reaches a thickness of about 3 mm. Ensure the water collection tray is empty and properly positioned below the low temperature compartment. 1) • Press the button (A) in the middle of the thermostat knob and close the door. Once all the ice has melted, the button will return to its original position and the refrigerator will automatically start functioning again. 2) For appliances without defrost button: • Turn the thermostat knob to the defrost position. • After defrosting, turn the knob back to its original position. It is not necessary to empty the rest of the refrigerator. Do not use sharp objects or metal instruments to remove ice. (Fig. 2) CARE AND MAINTENANCE Before any cleaning or maintenance operation, unplug the appliance from the mains or disconnect the electrical power supply. • Clean the interior periodically with a sponge soaked in warm water and/or neutral detergent. • Rinse the interior and dry thoroughly. • Clean the inside of the low temperature compartment when defrosting. • Clean the outside with a damp cloth. Do not use abrasive products, scourers, stain-removers (e. g. • Periodically clean air vents and the condenser at the rear of the appliance with a vacuum cleaner or a brush. In the event of prolonged disuse, leave the door open to prevent the formation of mould, odours and oxidation. Clean the appliance. Prolonged disuse 1. Disconnect the appliance from the power supply. Defrost and clean the interior. . 14 6gb33012. fm5 Page 15 Thursday, February 8, 2001 5:47 PM TROUBLESHOOTING GUIDE 1. • • • • • The appliance is not working. Is the plug properly inserted in the socket? [. . . ] The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the above procedures and reminders. If the plug and socket are not of the same type, have the socket replaced by a qualified electrician. • • • • • • • Do not use extension leads or adaptors. 15 6gb33012. fm5 Page 16 Thursday, February 8, 2001 5:47 PM ELECTRICAL CONNECTION For Great Britain only The wires in the mains lead are coloured in accordance with the following code: BLUE - “NEUTRAL” (“N”) BROWN - “LIVE” (“L”) GREEN AND YELLOW - “EARTH” (“E”) 1. The GREEN AND YELLOW wire must be connected to the terminal in the plug which is marked with the letter “E” or by the Earth symbol or coloured green or green and yellow. The BLUE wire must be connected to the terminal which is marked with the letter “N” or coloured black. [. . . ]