User manual WHIRLPOOL TRA 4020 INSTRUCTION FOR USE

[. . . ] Packaging material The packaging material can be 100% recycled, as confirmed by the recycling symbol ( ). Dryer The dryer is built from recyclable materials. If you decide to scrap the dryer act responsibly and observe local waste disposal by laws. Cut off the power cord so that the dryer cannot be connected to the mains. PRECAUTIONS Child safety • After use, set the programme selector to position “0”. [. . . ] The “Machine On” light goes off. Clean the lint filter at the end of each drying cycle. If you change the programme (Electronic dryer) during the drying cycle the dryer stops. To operate the new programme press the Start button again. Interruption of the drying cycle To interrupt the dryer during the drying cycle, set the programme selector knob to position ( ) Airing and press the Start button again for the Electronic dryer. Wait at least 5 minutes before opening the door to allow the dryer to cool down. For your safety the programme stops automatically if you open the door. To restart close the door and press the Start button again. 15 INSTALLATION • • Install your dryer in a room which is not subject to extreme conditions. When operating the tumble dryer, the room has to be adequately ventilated to avoid possible back flow of gases into the room from other appliances burning fuels, such as coal, gaz and including open fires. Remove the protective foil from the control panel. Level the dryer adjusting the 2 feet at the front. Take care not to trap the mains cable between the dryer and the wall. • • • Stacking kit Your dryer can be stacked on top of your washing machine, using the stacking kit AMH 542, which is available from your dealer. Minimum housing dimensions: Width: 600mm Height: 850mm Depth: 600mm ELECTRICAL CONNECTION • • The electrical connection has to be carried out in compliance with local regulations. Information on the permissible operating voltage, the power consumption and the required fuse protection is given on the rating plate on the back of the dryer. The earthing of this dryer is compulsory by law. Do not use extension cords or multiple adapters. Before any maintenance on the dryer, disconnect it from the mains supply. Do not operate the dryer if it has been damaged during transport. In case of replacement of mains cable contact a qualified service technician. • • • • • 16 ELECTRICAL CONNECTION 1) ELECTRICAL CONNECTIONS “Warning - this appliance must be earthed” This appliance is normally supplied with a mains lead having a plug fitted in the factory which has been checked for correct earth continuity. If the fitted plug is not suitable for your socket outlet, or if the machine’s mains lead is not fitted with a plug, you should fit a suitable new, good quality plug by following the instructions in (2) below. Any unsuitable plug should be cut off and disposed of in order to avoid a possible shock hazard should it be inserted into a socket. 2 pin with side earth contact) The wire which is coloured GREEN AND YELLOW must be connected to the earth contact. The other two wires should be connected to the two pins, irrespective of colour. 3) FUSE REPLACEMENT If the mains lead of this appliance is fitted with a BS 1363A 13 amp fused plug, replace the fuse only with an A. S. T. A. [. . . ] Wipe the cabinet with a mild household detergent. Clean the lint filter at the end of each drying cycle. If the lint filter mesh is clogged, clean it with water and a soft brush. Wipe away fluff at the door seal and the inside of the door using a damp cloth. TROUBLE SHOOTING GUIDE Should your dryer operate incorrectly, check the following points before calling for a qualified service technician. Drying is too long / laundry is not dry enough: • Have you selected the correct drying time or programme ? [. . . ]