User manual WHIRLPOOL TRAK 6221 INSTRUCTION FOR USE

[. . . ] Before any maintenance on the dryer disconnect it from the mains supply. Do not operate the dryer if it has been damaged during transport. Contact one of our After-Sales Service technicians. • Mains cables must be replaced by an original cable and is only to be carried out by a technician from AfterSales Service or an authorized electrician. [. . . ] • Wipe away lint from the door seal and the door using a damp cloth. • If the lint filter mesh is clogged, clean it with water and a soft brush. • If necessary, the power cable may be replaced with an identical one obtained from our After-Sales Service. The power cable must only be replaced by a qualified technician. 2. Energy saving tips • Always dry a full load: depending on the type of laundry and the programme/ drying time. By preference use the maximum spin speed allowed by your washing machine, since draining the water mechanically requires less energy. Clean the lint filter after every drying cycle. Place your dryer in a room with a temperature between 15° C and 20° C. In case of higher temperature ventilate the room. Always select the correct programme/drying time for the load in order to obtain the desired drying results. Select the gentle option only with small loads. When drying cotton, for example: dry iron dry and cupboard dry loads together. Start with the iron dry programme/drying time setting, remove the laundry to be ironed at the end of that cycle and dry the remainder of the load on the cupboard dry setting. • • 4. General recommendations • Always set the programme/ time selector knob to the “0” position after use. This prevents the dryer from being switched on accidentally. Before cleaning or carrying out maintenance, switch off the dryer and disconnect it from the mains supply. To clean the outside of the dryer, use a neutral detergent and a damp cloth. Do not use abrasive detergents. • • • • EC Declaration of Conformity • This dryer has been designed, constructed and distributed in compliance with the safety requirements of EC Directives: • 73/23/EEC Low Voltage Directive • 89/336/EEC EMC Directive • 93/68/EEC CE Marking Directive. • • • • • The dryer must be used in the household for the described uses. 12 Description of the Dryer A. To close the door: push gently until closed. Filter A B C D Reminder - Maintenance and Cleaning Filter Clean the lint filter at the end of every drying cycle: Open the door. Remove lint using a soft brush or your fingertips. 13 Vent Connection In some dryer models the vent hose together with an adaptor is supplied in the drum. If the hose and adaptor are not supplied as a standard the optional accessory AMH 577 kit, available at your dealer, can be used. Venting outside • Without kinking it, lead the vent hose outside (inside diameter 10 cm, maximum length with two bends 3 m). [. . . ] Insert the door lock system on the opposite side and lock it securely. Fix the 2 screws above and below the door lock system. Replace the contact pin in the inside of the door (top). C C D E F E 15 Troubleshooting Guide / After-Sales Service Troubleshooting Guide If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem: Drying takes too long / laundry is not dry enough: • • Was the correct programme selected?Was the inserted laundry too wet (Washing machine spin speed less than 800 rpm)? [. . . ]