User manual WHIRLPOOL TRAS 6230 PROGRAM CHART

[. . . ] After installation access to the mains plug has to be guaranteed, or the all-pole disconnection has to be possible with a switch. Stacking kit Your dryer can be stacked on top of your front loading washing machine. To do this, use stacking kit AMH 752, available at your dealer. • • Minimum housing dimensions: Width: Height: Depth: 600 mm 850 mm 560 mm 3. Installation • Do not install your dryer where it can be subject to extreme conditions, such as: poor ventilation, temperatures around freezing (or above 35°C). Remove the protective foil from the control panel. 2. [. . . ] Refit both into plug. 2) For the Republic of Ireland only The information given in respect of Great Britain will frequently apply, but a third type of plug and socket is also used, the 2-pin, side earth type. 3) Socket outlet / plug (valid for both countries) If the fitted plug is not suitable for your socket outlet, Please contact Whirlpool Service for further instruction. Please do not attempt to change plug yourself. This procedure needs to be carried out by a qualified Whirlpool technician in compliance with the manufactures instructions and current standard safety regulations. Important: The fuse cover must be refitted when changing a fuse and if the fuse cover is lost the plug must not be used until a correct replacement is fitted. Correct replacement are identified by the colour insert or the colour embossed in words on the base of the plug. Replacement fuse covers are available from your local electrical store. 11 Precautions and General Recommendations 1. Packing The packing box may be fully recycled as confirmed by the recycling symbol. 3. Disposing of packaging and old appliances The dryer is built from reusable materials. The dryer must be disposed of in compliance with local waste disposal regulations. Before scrapping, cut off the power cable so that the dryer cannot be connected to the mains. Children must not be allowed to play with the dryer. Clean the lint filter at the end of every drying cycle: 1. Remove lint using a soft brush or your fingertips. • Ensure that the vent hose does not sag when stacking the dryer on a washing machine. It should only be placed horizontally or upwards. • Do not connect to ventilation systems protected by fly nets. These can become clogged and cause malfunctioning of the dryer. • Never connect the air vent hose to a chimney or to a mechanical ventilation extractor duct. • Do not connect the vent hose to the heating system. Only connect the hose to ventilation systems insulated against humidity. Installing the vent hose A. Place a towel or the packing material on the right-hand side next to the dryer. Place the dryer on its righthand side (seen from the front) on the towel or the packing material. Push the adapter into the hose (see illustration). Attach the air vent hose adapter to the connection located under the dryer and lock it by means of the foreseen lugs. C Dryer operation without vent hose • Only use the dryer in a large, well-ventilated room. [. . . ] Remove the 2 door hinge screws, followed by the door. Unscrew the 2 screws above and below the door lock system. Removing the door lock: using a screwdriver, press down on the small rib in the upper opening and extract the door lock by pulling it towards you. Fasten the door on the desired side using the 2 screws. [. . . ]