User manual WHIRLPOOL TRK 4850/3 INSTRUCTION FOR USE

[. . . ] TABLE OF CONTENTS DESCRIPTION OF THE DRYER FILTER WATER CONTAINER BEFORE USING THE DRYER PRECAUTIONS PREPARING THE LAUNDRY SELECTING DRYING TIME OR PROGRAMME AND OPTIONS STARTING AND COMPLETING THE PROGRAMME INSTALLATION ELECTRICAL CONNECTION DRAINAGE SYSTEM DOOR REVERSIBILITY MAINTENANCE TROUBLE SHOOTING GUIDE AFTER-SALES SERVICE PAGE GB 14 14 15 15 15 16 17 18 19 19 21 21 22 23 23 PAGE PAGE PAGE PAGE PAGE PAGE PAGE PAGE PAGE PAGE PAGE PAGE PAGE PAGE To get full satisfaction from your dryer, please read carefully your instruction manual. 13 DESCRIPTION OF THE DRYER 1. Work-top Condensation water container Contact pin Door (Door opening can be reversed). See “Door reversibility” section. To close the door: push the door gently until it closes. [. . . ] Time programme (20 to 60 minutes) To gently finish dry or dry single items. Suitable for all fabrics. 17 SELECTING DRYING TIME OR PROGRAMME AND OPTIONS Time-steered dryer 1. Select the drying time and the options according to the table (see Programme Table). Options (if available) To select an option, press the corresponding button. Press the button again to cancel the option. Buzzer Pressing the button initiates a buzzer sound to signal at regular intervals, at the end of the drying cycle. Additional Programme Airing The laundry will be aired during 20 minutes without heating. STARTING AND COMPLETING THE PROGRAMME 1. Having selected the desired drying time or programme and options, press the Start button. If selected a buzzer sounds to signal the end of the drying cycle. It will sound at regular intervals for some time. If you do not unload the laundry at the end of the drying cycle, an automatic anti-crease cycle ( ) will operate for maximum 20 min. (Electronic dryer): the drum rotates at regular intervals preventing the laundry from creasing. On completion of the programme, set the programme selector knob to position “0”. The “Machine On” light goes off. Clean the lint filter and empty the water container at the end of each drying cycle. If you change the programme (electronic dryer) during the drying cycle the dryer stops. To operate the new programme press the Start button again. Interruption of the drying cycle To interrupt the dryer during the drying cycle, set the programme selector knob to position ( ) Airing and press the Start button again for the Electronic dryer. Wait at least 5 minutes before opening the door to allow the dryer to cool down. For your safety the programme stops automatically if you open the door. To restart close the door and press the Start button again. 18 INSTALLATION • • • • Install your dryer in a room which is not subject to extreme conditions. Remove the protective foil from the control panel. Level the dryer adjusting the four feet. [. . . ] Flush the heat exchanger under running water. To replace the heat exchanger, insert it into its bay and lock it in place with the retaining springs. N. B. The heat exchanger plates may discolour with use. 5. Wipe away fluff from the door seal and the inside of the door using damp cloth. 22 TROUBLE SHOOTING GUIDE Should your dryer operate incorrectly, check the following points before calling for a qualified service technician. Drying is too long / laundry is not dry enough: • Have you selected the correct drying time or programme ?• Was the inserted laundry too humid (Washing machine spin speed less than 800 rpm)? [. . . ]