User manual WHIRLPOOL TRK 69760 PROGRAM CHART

[. . . ] Start delay indicator blinks and the count-down is running by reducing the time in one hour steps. The count-down is indicated by the blinking of the start-delay indicator located above the button. During count-down the drum will turn from time to time to redistribute the laundry and the pump may be heard working for a short time. To cancel or to change the previously set time turn programme selector knob to “0” or open the door. [. . . ] Important: only use specific indicated dryer-safe additives and rinse items that have been treated with stain remover thoroughly in plenty of water before drying. Only use specific indicated dryer-safe plastic items and never dry rubber or articles contaminated with vegetable oil in the dryer DRUM LIGHT OPTION (Option only available when Programme is selected). Push the button to turn the drum light on for 30 sec. and push again to turn the drum light off. SELECTING A PROGRAMME & OPTIONS Programme and Options: • To select a programme, turn the programme selector knob to the required position. The Start/Pause indicator lamp is blinking, indicating that the cycle needs to be started. • To select an option, press the corresponding button. The indicator light above the button lights up confirming that the selection has been made. • Press the option button again to cancel the option. STARTING & COMPLETING A PROGRAMME 1. Having selected the desired programme and options, press the Start/Pause button. If the laundry is not removed at the end of the drying cycle, an automatic anti-crease cycle will operate for maximum 60 min. The drum rotates at regular intervals, preventing the laundry from creasing. Anti-Crease protection re-distributes laundry in the drum. When the Anti-Crease option is selected and laundry has not been taken out, an anti-crease cycle is activated for 12 hrs. On completion of the programme, set the programme selector knob to position “0”. CHANGING A PROGRAMME When changing the programme during the drying cycle, the dryer stops. The Start/ Pause indicator lamp is blinking. To operate the new programme, press the Start/Pause button. INTERRUPTING A PROGRAMME To interrupt the dryer during operation 1. Set the programme selector knob to Airing. Wait at least 5 minutes before opening the door to allow the dryer to cool down. For your safety the programme stops automatically if you open the door. [. . . ] All programme sequence indicators blinking: • Service call necessary. Replacing the drum light bulb (if supplied): • If the inside lamp does not work, the bulb may be faulty. • Open the door and unscrew the glass cover insie the drum. • Replace the faulty bulb with a new one and screw the glass cover back on. [. . . ]