User manual WHIRLPOOL TRK 9960 PROGRAM CHART

[. . . ] The Start/Départ indicator lamp is blinking, indicating that the cycle needs to be started (for information, refer to programme table). Select the option required by pressing the corresponding button. The indicator lamp above the relevant button lights up to confirm your selection. An alarm sounds if an incorrect selection is made (incompatible options). [. . . ] 2. 5 kg Laundry made from synthetic fibres such as polyamide, nylon, polyacrylic, etc. Delicate Delicate 2. 5 Max. 2. 5 kg - X X X - 100’ 85’ Airing Laundry is aired and refreshed for 30 minutes without heating. - - - X X X - - Time/cycle Completes drying or dries single items (suitable for all fabrics). - X - X X X * Test programme in accordance with EN 61121. 2 How to proceed if . . . Clean the filter at the end of every cycle. • • • • • • Open the door. Brush lint using a soft brush or your fingertips. Push the filter back into place. . . . you want to correctly care for and clean your dryer: Empty the water container at the end of each drying cycle. Clean the heat exchanger at least every month. (For further information see chapter “Heat Exchanger” in the Instructions for Use). • Pull the handle to remove the water container. • Replace the water container when empty by pushing it completely back in place. • Remove fibres in and around the water evacuation hole at least once per month. Drying takes too long / laundry is not dry enough. • Has the correct drying programme been selected?• Was the inserted laundry too wet (washing machine spin speed less than 1000 rpm)?• Is the lint filter dirty (filter indicator light on)?(for more information, refer to the instructions for use) • Is the room temperature too high?• Are the “END” and “Anti-crease” indicator lamps lighting up?The drying cycle is complete and the laundry can be taken out. • Is the plug properly inserted into the mains electricity socket?• Has a drying programme been selected?• Has the Start/Départ button been pressed?• Has the start-delay option been selected?• Has the water container been inserted correctly?• Has the heat exchanger been inserted correctly?• Has any fluff on the heat exchanger seal been wiped away?• Has any fluff on the door seal been wiped away?• Has the water container been inserted correctly? [. . . ] The countdown is indicated by the indicator lamp above the button flashing. During the countdown, the drum will turn from time to time to re-distribute the laundry. To cancel or change the previously set time delay, set the index of the programme selector knob to the top, or open the door. Dryness adjustment This is an option to adjust the dryness of the laundry according to your wishes. Select the desired programme and the option dryness level adjustment by pressing the button “+” for more dry or the button “-” for more humid. [. . . ]