User manual WHIRLPOOL TT 162 D PRODUCT FICHE

[. . . ] made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton. Heavily soiled curtains and delicate clothing, dresses, skirts, shirts and blouses. Normally soiled bed linen, table linen and underwear, towels, shirts etc. Slightly to normally soiled bed linen, table linen and underwear, towels, shirts etc. , made of cotton and linen. [. . . ] made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton. Slightly soiled overalls and sportswear made of cotton, polyester, polyamide and blends with cotton. Curtains and delicate clothing, dresses, skirts, shirts and blouses. Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable. Textiles made of silk, linen, wool and viscose marked as “handwashable”. Same as the last two rinses and the final spin in the “Synthetic” programme. Programme for treating wash with starch or softener. Same as the last rinse and the final spin in the “Cotton” programme. Programme for treating wash with starch or softener. In this programme spinning is intensive. Press the “On/Off” button again to start the “Drain” programme . Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with standard IEC 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. The data on the “Energy Label” refer to the programme “Cotton 60° C”. * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. PREPARATION OF WASH CYCLE 1. Load the machine, close the drum flaps and check that they are properly locked. Add detergents and additives into the dispenser to no more then the “MAX” level mark, as follows: • Programme with pre and main wash • Main wash programme without prewash • Fabric softeners and conditioners • Chlorine bleach • Stain remover agents • Anti-scale agents (if necessary) 3. Turn the programme selector knob to the desired programme. Turn the temperature selector knob to the desired temperature. Turn the spin speed selector knob to the desired spin speed. [. . . ] Turn the spin speed selector knob to the desired spin speed. If the spin speed “0” is selected, the final spin is cancelled, but not the intermediate spins. The programme ends with a drain cycle. SELECT THE DESIRED OPTION Selecting or deselecting an option can be done at any time during the programme. The option will be applied as long as the corresponding programme phase has not been executed yet. [. . . ]