User manual WHIRLPOOL UKF8001AXX

[. . . ] NOTE: For undercounter installation, it is recommended that the junction box be located in the adjacent right or left cabinet. If you are installing the junction box on rear wall behind oven, the junction box must be recessed and located in the upper or lower right or left corner of the cabinet; otherwise, the oven will not fit into the cabinet opening. # 8­14 x 1" screws - single oven (2), double oven (4) Bottom vent (supplied on some models) Two # 8­18 x ³/" screws - bottom vent Side trim Oven support surface must be solid, level and flush with bottom of cabinet cutout. Floor must be able to support a single oven weight of 154 lbs (70 kg) or a double oven weight of 287 lbs (130 kg). [. . . ] This oven must be connected to a grounded metal, permanent wiring system. Be sure that the electrical connection and wire size are adequate and in conformance with the National Electrical Code, ANSI/NFPA 70-latest edition or CSA Standards C22. A copy of the above code standards can be obtained from: National Fire Protection Association One Batterymarch Park Quincy, MA 02269 CSA International 8501 East Pleasant Valley Road Cleveland, OH 44131-5575 To properly install your oven, you must determine the type of electrical connection you will be using and follow the instructions provided for it here. Oven must be connected to the proper electrical voltage and frequency as specified on the model/serial number rating plate. The model/serial number rating plate is located at the bottom of the right-hand mounting rail. Connect directly to the circuit breaker box (or fused disconnect) through flexible, armored or nonmetallic sheathed, copper cable (with grounding wire). see "Make Electrical Connection" section. Flexible conduit from the oven should be connected directly to the junction box. If the house has aluminum wiring, follow the procedure below: 1. Aluminum/copper connection must conform with local codes and industry accepted wiring practices. Locate existing wiring to avoid drilling into or severing wiring during installation. Excessive Weight Hazard Use two or more people to move and install oven. Failure to do so can result in back or other injury. Using 2 or more people, lift oven partially into cabinet cutout. Use the oven opening as an area to grip. NOTE: Push against seal area of oven front frame when pushing oven into cabinet. With one # 8­18 x ³/" screw (C) for each side of the vent, fasten vent securely to the oven. Push against seal area of front frame to push oven into cabinet until shipping feet almost contact cabinet. Slide top end of each trim piece upward onto oven side rails. On models with shipping feet, use a Phillips screwdriver to remove screws attaching the shipping feet. Push oven completely into cabinet and center oven into cabinet cutout. Securely fasten oven to cabinet using the # 8­14 x 1" screws (2 for single oven, 4 for double oven) provided. [. . . ] For oven use and cleaning, read the Use and Care Guide. Make sure the oven door is closed and the "ON" light is shown in the display. Use the 8-18 x ³/" screws, located in the screw bag assembly, to attach each trim piece to oven. Replace oven door by inserting ends of hinges into hinge slots in the oven frame. [. . . ]