User manual WHIRLPOOL UMC5165AS INSTALLATION GUIDE

[. . . ] Read and follow the instructions provided with any tools listed here. Recommended region for receptacle location (no less than 6" [15. [. . . ] 0 cm) WARNING: Improper use of the grounding plug can result in a risk of electric shock. Consult a qualified electrician or serviceman if the grounding instructions are not completely understood, or if doubt exists as to whether the microwave oven is properly grounded. If the power supply cord is too short, have a qualified electrician or serviceman install an outlet near the microwave oven. Unplug microwave oven before proceeding with installation. Remove any loose items inside microwave oven. Gently turn microwave oven onto its top, with the door facing forward (toward installer). Align the two rails on the microwave oven bottom, as shown, making sure the flanges are forward and pointing up. wARNING Electrical Shock Hazard Plug into a grounded 3 prong outlet. Failure to follow these instructions can result in death, fire, or electrical shock. observe all governing codes and ordinances. Required: ■ A 120 volt, 60 Hz, AC only, 15- or 20-amp electrical supply with a fuse or circuit breaker. Secure the rails to the microwave oven bottom using four short screws. 3 Prepare Cutout/Cabinet Opening 1. On the cutout floor, find and mark the centerline. [. . . ] Secure trim kit frame to cutout/cabinet by installing four long wood screws (painted) into the pilot holes drilled in Step 2 above. Holding the trim kit frame in place, use 7/64" drill to drill four pilot holes into the front facing of the cutout/cabinet through the mounting hole guides in the upper and lower corners of the trim kit frame. [. . . ]