User manual WHIRLPOOL UXL6036YSS

[. . . ] For questions about features, operation/performance, parts, accessories or service, call: 1-800-253-1301 or visit our website at www. Com In Canada, call 1-800-807-6777 or visit our website at www. Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. [. . . ] Use the inside set of mounting holes for the single motor system. Use the outside set of mounting holes for the dual motor system. Five 6 mm nuts are required for the dual motor system. Clip nuts into the small square notches, one located in the front of the square vent opening and the other four located at the left and right ends of the square vent opening. Install the hood liner blower motor assembly inside the hood liner canopy with the wiring connection to the left for the single motor system and to the front or top for the dual motor system. Run the power supply wires and connector from the range hood through the hole in the right end of the motor mounting plate. Push the right end of the motor mounting plate up and snap it into the spring tab. NOTE: The spring tab should be outside the slot in the mounting plate. Align mounting holes in motor mounting plate with motor mounting clip nuts and install 6 x 16 mm screws and 6. 4 mm lock washers (quantity 2 for single motor; quantity 5 for dual motor). Attach power cord connector from the range hood to connector on wiring box. Pull the spring clip to release the blower motor assembly. Remove the blower motor assembly from the housing and place it on a covered surface. Power supply connector from range hood NOTE: Your hood liner requires you to purchase either an internal type or an in-line (external type) blower motor system. NOTE: The blower motor housing can be mounted using 4 holes from either the inlet side or the outlet side of the blower. The in-line blower system must be fastened to a secure structure of the roof, ceiling, wall, floor, or new or existing frame construction. The 4 holes on either the inlet (bottom) side or the outlet (top) side of the blower must be used to mount the in-line blower system to the structure. Plywood may be used to span open areas between ceiling joists or roof rafters to aid installation. This structure must be strong enough to support the weight of the in-line blower system (50 lb [22. Excessive Weight Hazard Use two or more people to move and install in-line blower motor system. Failure to do so can result in back or other injury. Using two or more people, move the in-line blower motor system to the mounting location. [. . . ] iTEMS EXCLUDED FROM WARRANTY This limited warranty does not cover: 1. Service calls to correct the installation of your major appliance, to instruct you on how to use your major appliance, to replace or repair house fuses, or to correct house wiring or plumbing. Service calls to repair or replace appliance light bulbs, air filters or water filters. Consumable parts are excluded from warranty coverage. [. . . ]