User manual WHIRLPOOL UXT2030ADW USE & CARE GUIDE

[. . . ] 2 CM) RANGE HOOD Installation Instructions and Use & Care Guide For questions about features, operation/performance, parts, accessories or service, call: 1-800-253-1301 or visit our website at www. Com In Canada, call 1-800-807-6777 or visit our website at www. RANGE HOOD SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. [. . . ] Prepare Range Hood Align the exterior edge of the mounting brackets with the exterior edges of the upper cabinet. IMPORTANT: The brackets should touch the upper cabinet. With a pencil, mark the upper holes on the brackets. – ■ Set the range hood on its back on a covered surface. Using a #2 Phillips screwdriver, remove the 7" (17. 8 cm) round vent mounting plate attached with 3. Using a #2 Phillips screwdriver, remove the electrical box cover. Using a flat-blade screwdriver, remove the appropriate power supply knockout. 8 cm) round vent mounting plate, draw the vent opening outline on the underside of the cabinet: Place the vent mounting plate on the bottom of the cabinet. Position the edge of the plate with the widest distance (A) between the hole and edge of the mounting plate against the wall. Position the side edges of the mounting plate between the dots marked previously. IMPORTANT: The widest edge (A) of the vent mounting plate must be positioned against the wall. 8 cm) vent opening (solid line) on the cabinet bottom. Using a jigsaw or keyhole saw, cut the vent opening 1" (2. Lift the range hood into place and insert the mounting bracket tabs through the slots in the back of the range hood. Drill Electrical Opening C C B Hold the range hood firmly in place with one hand and bend each mounting tab (A) upward approximately 90°. Mark the hole at the power supply knockout (B). Mark the 4 vent hole locations (C) on the top of the range hood. OPTIONAL: Mark the hole in each mounting tab. remove the range hood and set it aside. Using a 1¹⁄₄" (3 cm) drill bit, drill the hole in the dot marked previously at the electrical strain relief. OPTIONAL: Using a ¹⁄₈" (3 mm) drill bit, drill pilot holes for the dots marked previously at each mounting tab at an approximate 45° angle in an upward direction. [. . . ] This major appliance is designed to be repaired in the home and only in-home service is covered by this warranty. Repairs to parts or systems resulting from unauthorized modifications made to the appliance. Expenses for travel and transportation for product service if your major appliance is located in a remote area where service by an authorized Whirlpool servicer is not available. The removal and reinstallation of your major appliance if it is installed in an inaccessible location or is not installed in accordance with published installation instructions. [. . . ]