User manual WHIRLPOOL UXT4230ADW USE & CARE GUIDE

[. . . ] 4 CM) RANGE HOOD Installation Instructions and Use & Care Guide For questions about features, operation/performance, parts, accessories or service, call: 1-800-253-1301 or visit our website at www. Com In Canada, call 1-800-807-6777 or visit our website at www. RANGE HOOD SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. [. . . ] IMPORTANT: The brackets should touch the upper cabinet. With a pencil, mark the upper holes on the brackets. –  ■ Set the range hood on its back on a covered surface. Using a #2 Phillips screwdriver, remove the rectangular damper attached with 3. Using a #2 Phillips screwdriver, remove the electrical box cover. Using a flat-blade screwdriver, remove the appropriate power supply knockout. 4 cm) Rectangular Vent System Lift the range hood into place and insert the mounting bracket tabs through the slots in the back of the range hood. –  45˚+ 90˚ A A Using a ¹⁄₂" (13 mm) drill bit, drill a hole in each of the dots marked previously on either the wall or upper cabinet. Using the outside edges of the holes, mark the vent opening. Using a jigsaw or keyhole saw, cut the vent opening. 8 cm) round vent mounting plate, draw the vent opening outline on the underside of the cabinet: Place the vent mounting plate on the bottom of the cabinet. Position the edge of the plate with the widest distance (A) between the hole and edge of the mounting plate against the wall. Position the side edges of the mounting plate between the dots marked previously. IMPORTANT: The widest edge (A) of the vent mounting plate must be positioned against the wall. 8 cm) vent opening (solid line) on the cabinet bottom. Using a jigsaw or keyhole saw, cut the vent opening 1" (2. D D Hold the range hood firmly in place with one hand and bend each mounting tab (A) upward approximately 90°. Mark the hole at the power supply knockout (B). for a non-vented (recirculating) installation: Go to Step 7. For a top vented installation: Mark the 4 vent hole locations (C) on the top of the range hood. Attach the screws to the cabinet side walls. For direct wire installations, run the home power supply cable according to the National Electric Code or CSA standards and local codes and ordinances. [. . . ] In the event of product replacement, your appliance will be warranted for the remaining term of the original unit's warranty period. This limited warranty is valid only in the United States or Canada and applies only when the major appliance is used in the country in which it was purchased. This limited warranty is effective from the date of original consumer purchase. Proof of original purchase date is required to obtain service under this limited warranty. [. . . ]