User manual WHIRLPOOL UXT5230BDB USE & CARE GUIDE

[. . . ] 4 CM) RANGE HOOD Installation Instructions and Use & Care Guide For questions about features, operation/performance, parts, accessories or service, call: 1-800-253-1301 or visit our website at www. Com In Canada, for assistance, installation and service, call 1-800-807-6777 or visit our website at www. RANGE HOOD SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. [. . . ] IMPORTANT: The brackets should touch the upper cabinet. With a pencil, mark the upper holes on the brackets. Install Brackets Lift the range hood into place and insert the mounting bracket tabs through the slots in the back of the range hood. 8 cm) round vent mounting plate, draw the vent opening outline on the underside of the cabinet: Place the vent mounting plate on the bottom of the cabinet. Position the edge of the plate with the widest distance (A) between the hole and edge of the mounting plate against the wall. Position the side edges of the mounting plate between the dots marked previously. IMPORTANT: The widest edge (A) of the vent mounting plate must be positioned against the wall. - D D ■ Hold the range hood firmly in place with one hand and bend each mounting tab (A) upward approximately 90°. Mark the hole at the power supply knockout (B). OPTIONAL: Mark the hole in each mounting tab. for a non-vented (recirculating) installation: Go to Step 7. For a top vented installation: Mark the 4 vent hole locations (C) on the top of the range hood. For a rear vented installation: Mark the 4 vent hole locations (D) on the rear of the range hood. 8 cm) vent opening (solid line) on the cabinet bottom. Using a jigsaw or keyhole saw, cut the vent opening 1" (2. 4 cm) Rectangular Vent System Using a 1¹⁄₄" (3 cm) drill bit, drill the hole in the dot marked previously at the electrical strain relief. 8 ■ Tighten the strain relief screws. NOTE: Do not reconnect power until the installation is complete. OPTIONAL: If you prefer, bend the rear tabs against the rear of the range hood and attach to the wall using #8-18 x ⁵⁄₈" (4. Option 2 - Power Cord Kit Installations For optional power cord kit installations, follow the instructions supplied with the power cord kit. See the “Assistance or Service” section for information on ordering. NOTE: Use only with range hood cord connection kits that have been investigated and found acceptable for use with this model range hood. [. . . ] This major appliance is designed to be repaired in the home and only in-home service is covered by this warranty. Repairs to parts or systems resulting from unauthorized modifications made to the appliance. Expenses for travel and transportation for product service if your major appliance is located in a remote area where service by an authorized Whirlpool servicer is not available. The removal and reinstallation of your major appliance if it is installed in an inaccessible location or is not installed in accordance with published installation instructions. [. . . ]