User manual WHIRLPOOL W10021230-D-WH

[. . . ] ® Undercounter Dishwasher PRODUCT MODEL NUMBERS GU3600XTS Electrical: 120-volt, 60-Hz, AC-only, 15- or 20-amp fused electrical supply. A time-delay fuse or circuit breaker and separate circuit is recommended. [. . . ] Do not solder within 6" (15. 2 cm) from water inlet valve. Drain: Use the new drain hose supplied with your dishwasher. If this is not suitable, use a new drain hose with a maximum length of 12 feet (3. 7 m) that meets all current AHAM/IAPMO test standards, is resistant to heat and detergent, and fits the 1" (2. 5 cm) drain connector of the dishwasher. Must have a high drain loop 20 inches (50. 8 cm) above the subfloor or floor. Connect drain hose to waste tee or disposer inlet above drain trap in house plumbing and 20 inches (50. 8 cm) minimum above the floor. An air gap must be used if the drain hose is connected to house plumbing lower than 20 inches (50. 8 cm) above subfloor or floor. drain line fittings. OVERALL DIMENSIONS 3/4" (1. 9 cm) insulation ­ may be compressed (not used on all models) 25" (63. 5 cm) 23-7/8" (60. 6 cm) 33-7/8" (86 cm) min. with wheels removed 21" (53. 3 cm) Side view Rear view CABINET OPENING DIMENSIONS 24" (61 cm)** All surfaces must be free from intrusions 24" (61 cm) min. 3-1/4" (8. 3 cm) 2" (5. 1 cm) 6" *** (15. 2 cm) 3-1/2" (8. 9 cm) 3-1/4" (8. 3 cm) 2" (5. 1 cm) 6" *** (15. 2 cm) 34" (86. 4 cm) min. * 5-1/2" (14 cm) 2" 9" (5. 1 cm) 10" (22. 9 cm) (25. 4 cm) 2-3/4" 3-1/4" (7 cm) (8. 3 cm) 3-1/4" 2-3/4" (8. 3 cm) (7 cm) Cut holes in shaded area of cabinet walls or floor as specified below: water line ­ 1/2" (1. 3 cm) drain line ­ 1-1/2" (3. 8 cm) direct wire ­ 3/4" (1. 9 cm) power supply cord ­ 1-1/2" (3. 8 cm) * Measured from the lowest point on the underside of countertop. May be reduced to 33-7/8" (86 cm) by removing wheels from dishwasher. [. . . ] For complete details, see Installation Instructions packed with product. Specifications subject to change without notice. [. . . ]