User manual WHIRLPOOL W3CG3014XW INSTALLATION GUIDE

[. . . ] W10526074A COOKTOP SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This symbol alerts you to potential hazards that can kill or hurt you and others. [. . . ] Electronic ignition systems operate within wide voltage limits, but proper grounding and polarity are necessary. Check that the outlet provides 120-volt power and is correctly grounded. The wiring diagrams are provided with this cooktop. see “Wiring Diagrams” section. – 5 Gas Supply Line ■ Gas Pressure Regulator The gas pressure regulator supplied with this cooktop must be used. The inlet pressure to the regulator should be as follows for proper operation: Natural Gas: Minimum pressure: 5" (12. 5 cm) WCP Contact local gas supplier if you are not sure about the inlet pressure. A smaller size pipe on longer runs may result in insufficient gas supply. Pipe-joint compounds that resist the action of LP gas must be used. With LP gas, piping or tubing size should be ½" minimum. Usually, LP gas suppliers determine the size and materials used in the system. Flexible stainless steel tubing gas connector, designed by CSA to connect the cooktop to the rigid gas supply line. Burner Input Requirements ■ A ½" male pipe thread is needed for connection to the female pipe threads of the inlet to the cooktop pressure regulator. Do not kink or damage the flexible metal tubing when moving the cooktop. ■ Rigid pipe connection: The rigid pipe connection requires a combination of pipe fittings to obtain an in-line connection to the cooktop. The rigid pipe must be level with the cooktop connection. All strains must be removed from the supply and fuel lines so cooktop will be level and in line. Input ratings shown on the model/serial rating plate are for elevations up to 2, 000 ft (609. 6 m), ratings are reduced at a rate of 4% for each 1, 000 ft (304. 8 m) above sea level (not applicable for Canada). 5 m) a high altitude kit is needed to avoid any reduced power output. see separate LP gas conversion instructions sheet. [. . . ] The surface burner “low” flame should be a steady blue flame approximately ¼" (0. A Check Operation of Surface Burners Push in and turn the surface burners control knobs to the “LITE” position. The surface burner flame should light within 4 seconds. The first time a surface burner is lighted it may take longer than 4 seconds to light because of air in the gas line. [. . . ]