User manual WHIRLPOOL W4TXNWFWT WARRANTY INFORMATION

[. . . ] All other charges, including transportation charges for replacements under this warranty and labor costs not specifically covered by this warranty, shall be borne by you. This warranty is extended only to the original purchaser of the U-Line product. The Registration Card included with the product should be promptly completed by you and mailed back to U-Line. The following are excluded from this limited warranty: installation charges; damages caused by disasters or acts of God, such as fire, floods, wind and lightening; damages incurred or resulting from shipping, improper installation, unauthorized modification, or misuse/abuse of the product; customer education calls; food loss/spoilage; door and water level adjustments (except during the first 90 days from the date of purchase); defrosting the product; adjusting the controls; door reversal; or cleaning the condenser. [. . . ] Pull door gasket out of groove (top edge of door only). Start in the middle and pull outward, moving toward the edge (see Figure 19). Do not remove the three screws behind the gasket. Pull handle up and off. UL132 UL310 2. Figure 17 3. 4. Figure 18 NOTE Use care not to bend light switch bracket (where installed), located on door bottom when installing door insert. Do not set door on bottom edge when pushing insert into place. 5. UL117 Slide custom door panel insert into 1/4 inch channel in door front. Figure 19 15 User's Manual 6. Holding door gasket out of the way, replace handle on door making sure it is seated properly on insert and that screw holes line up. Install two small screws removed in step 2. Starting at the corners and working inward, push door gasket into place on door. Place door on bottom hinge pin and install upper hinge screw. 7. 9. BUILT-IN INSTALLATION Your U-Line product has been designed for either free-standing or builtin installation. During periods of limited usage or high ambient temperatures, it is common for cubes to fuse together. If ice maker is not used regularly, the ice bucket should be emptied periodically to ensure fresh cubes. It is normal for cubes to appear cloudy. This is caused by air being trapped in the water due to fast freezing. It has nothing to do with the health, taste or chemical make-up of the water. It is the same air that is in every glass of water you drink. 18 The ice bin door must be fully closed with the door lip inside the ice bucket. Frost free models: Do not place any objects over air inlet or outlet in freezer section. For frost free models: Light frosting may occur in high humidity conditions or if the ice bucket is not pushed in completely. BI 2015 is not frost free and must be defrosted periodically. Do not place cans or bottles so they are touching the back of the unit. If placed against the evaporator section, cans or bottles may freeze. ADJUSTING THE TEMPERATURE CONTROL CONTROL KNOB Series 2015 and 2075: Adjust control setting by turning the numbered knob attached to the front grille (see Figure 23). 2 1 WARMER 4 3 5 6 7 COLDER UL315 CHECKING TEMPERATURE To accurately check the temperature, insert an accurate thermometer into a plastic (non-breakable) bottle, partially filled with water. [. . . ] Dry out excess water from the ice maker assembly. Prop the door open at least two inches to allow for air circulation and prevent mold and mildew. Disconnect unit from main electrical power source. Leave water supply line and power cord disconnected until ready to reuse. NOTE The use of anti-freeze or other products of this nature is not necessary and is not recommended. 28 TROUBLESHOOTING BEFORE CALLING FOR SERVICE If the unit appears to be malfunctioning, read through NORMAL OPERATION first. [. . . ]