User manual WHIRLPOOL W6TXNWFWT DIMENSION GUIDE

[. . . ] All other charges, including transportation charges for replacements under this warranty and labor costs not specifically covered by this warranty, shall be borne by you. This warranty is extended only to the original purchaser of the U-Line product. The Registration Card included with the product should be promptly completed by you and mailed back to U-Line or you can register on-line at www. U-LineService. com. The following are excluded from this limited warranty: installation charges; damages caused by disasters or acts of God, such as fire, floods, wind and lightening; damages incurred or resulting from shipping, improper installation, unauthorized modification, or misuse/abuse of the product; customer education calls; food loss/spoilage; door and water level adjustments (except during the first 90 days from the date of purchase); defrosting the product; adjusting the controls; door reversal; or cleaning the condenser. [. . . ] Do not remove the three screws behind gasket. Remove two outside screws holding door handle. Slightly separate door handle from door (Figure 26). Remove outer door panel and cardboard spacer. Slide custom door panel insert into 1/4 inch channel in door front. Holding door gasket out of the way, replace handle on door making sure it is seated properly on insert and that screw holes line up. Install two small screws removed in step 3. Starting at the corners and working inward, push door gasket into place on door. Place door on bottom hinge pin and install upper hinge screw. 21 Figure 26 Figure 25 UL310 Figure 24 2. 3. 4. DWR020 5. 8. UL132 9. User's Manual INITIAL START-UP Once installation and leveling is complete, the unit is ready for initial start-up and operation. To display actual temperature in the refrigerator, press the "WARMER" button momentarily. A solid status indicator light (1, Figure 28) will show and the air temperature reading in the cabinet will show for approximately 10 seconds. To adjust the temperature set point, press the "SET TEMP" button momentarily; the display will flash. Press the "WARMER" or "COOLER" button as desired to change the set point. When the desired set point shows on the display, wait 10 seconds and the new set point will be saved. Wait 24 hours for the temperature to stabilize before checking the actual temperature again. 23 User's Manual Refer to Table 1 to determine indicator light status. LED 1 2 Status · Solid · Flashing · Solid · Flashing · Solid · Flashing Indicates · Refrigerator Temperature displayed · Not Applicable · Service Menu ­ wait 10 seconds and it will exit automatically · Open Thermistor ­ call for service · Service Menu ­ wait 10 seconds and it will exit automatically · Drain Pump Blocked ­ check installation and drain line. Indicator Light Status 24 CLEAR ICE MAKER OPERATION The ice maker side is designed to make clear ice from most water sources on a consistent basis. Water is constantly circulated over the evaporator assembly. As the water freezes, gravity causes any sediment to drop into the water trough and not become imbedded in the ice. This gives a clearer ice cube with a low mineral content. [. . . ] Check to see that water is connected and turned on to the unit. Door is not closing completely. Temperature controller LED flashing. Noise during operation. Cycle Selector Switch in OFF position. Drain pump blocked. Unit malfunction. Certain sounds are normal. Fresh food section on Combo units too cold. [. . . ]