User manual WHIRLPOOL WA 2362 INSTRUCTION FOR USE

[. . . ] 03769-gb. fm5 Page 20 Monday, October 8, 2001 3:42 PM GB QUICK REFERENCE GUIDE THE FIRST TIME THE APPLIANCE IS USED: • FOLLOW THE “INSTALLATION INSTRUCTIONS” • REMOVE THE TRANSIT BOLTS BEFORE USING THE APPLIANCE • First wash cycle without laundry: 1. Pour a small amount of detergent (about 100 ml) into the detergent dispenser compartment . Select a short programme (see programme chart). The pilot lamp lights up to show that the appliance is switched on. [. . . ] Note: Leave the door ajar so that the drum can dry. PROGRAMME RESELECTION / INTERRUPTION PROGRAMME RESELECTION a. CONTINUING WITH A NEW PROGRAMME OR TEMPERATURE SETTING 1. Select the new programme or temperature setting. Hold down the “Start” button for about one second. The new programme continues with the same programme step at which the previous programme was interrupted. CANCELLING THE CURRENT PROGRAMME AND RESTARTING WITH A NEW ONE Do not put more detergent into the machine for the new programme, since almost no water is drained out when a programme is cancelled. Hold down the “Start” button for 5 seconds, or until the programme control audibly restarts. Wait until the programme sequence indicator has returned to its initial (leftmost) position and has disappeared. Set the programme selector to “0”. Select the new programme, temperature and any special options desired. Hold down the “Start” button for one second. 28 TO INTERRUPT/PAUSE A PROGRAMME To interrupt the current programme for a certain time and resume it later: 1. Set the programme selector to “0”. After the desired time, reselect the programme. Hold down the “Start” button for about one second. The programme continues. TO STOP A PROGRAMME BEFORE THE END AND DRAIN To stop a programme before the end and drain the water: 1. Set the programme selector to "Drain". Hold down the “Start” button for about one second. Only open the door when the programme sequence indicator has returned to its initial (leftmost) position and the “Door Closed” indicator is off. 03769-gb. fm5 Page 29 Monday, October 8, 2001 3:42 PM REMOVING THE FILTER / DRAINING RESIDUAL WATER WHEN SHOULD THE FILTER BE REMOVED? • • • Check the filter regularly, two or three times a year and clean it if necessary. Check the filter if the appliance is not draining properly or if it fails to perform spin cycles. Remove the filter if the pump is blocked by an object (buttons, coins, safety pins, etc. ). IMPORTANT: make sure the water has had time to cool before draining the appliance. REMOVING THE FILTER 1. [. . . ] The mesh filter supplied with the appliance must be inserted in the connection between the inlet hose(s) and the tap(s). Carefully screw the hose connection to the tap(s) preferably by hand. Make sure there are no kinks in the hose and that it is not crushed. Check water-tightness of tap(s) and appliance connections by turning the tap(s) completely on. [. . . ]