User manual WHIRLPOOL WA 74 SD A PRODUCT FICHE

[. . . ] You save on water, energy and time as a result. • Thanks to its Dynamic-Sense Technology the appliance adapts optimally to the prevailing circumstances, achieving favourable consumption figures even in the case of small loads. Water supply temperature and pressure, quantity of water and degree of loading, are the parameters taken into account. The progamme duration is influenced by these factors. [. . . ] The programme can now be started immediately by pressing this button. • If the programme is changed after the start delay, the start delay option is cleared and the remaining time is displayed. The indicator above the “Start/Pause” button flashes. Note: With liquid detergent, a dosing aid placed directly in the drum should be used if a start delay has been selected. 29 DOOR LOCK / PROGRAMME END DOOR LOCK The door locks automatically after the programme starts until the end of the programme. The “Door free” indicator goes out. Exception: In the programmes Cotton and Synthetics and during the prewash for these programmes, the door can be opened in order to add further items during the first 15 minutes after the start of the programme. This is not possible if “Rapid Wash” is selected. If the programme selector is moved to the “ ” position or if the electricity supply is interrupted, then after approximately two minutes the door is released. PROGRAMME END The programme end is indicated by: • The “Door Free” indicator coming on and the remaining time indicator (if available) showing “0:00”, • An audible tone is sounded three times, • The programme sequence indicators are all off. CHANGING / INTERRUPTING / CLEARING PROGRAMME CHANGING PROGRAMME OR OPTIONS 1. Set programme selector knob to new programme. Reselect additional options and spin speed if appropriate. The indicator light above the “Start/Pause” button will blink. Pour 0. 5 l of water into the detergent dispenser to reactivate the “Eco System”. Connect the appliance to the electrical outlet. Select a programme and start it. WHEN SHOULD I DRAIN RESIDUAL WATER? • • Before transporting (moving) the machine. If the appliance is installed in a room subject to sub-zero temperatures. It is best in this case to drain the machine after every wash. DRAINING RESIDUAL WATER The residual water drain hose is accommodated behind the appliance plinth. Before draining residual water unplug the machine. Remove carefully the plinth using the thin rounded projection of the coloured insert from the detergent drawer. Remove the cap from the end of the tube. Allow all the water to flow into a flat bowl, then refit the cap and stow the drain tube back in its compartment. Before using the machine again, pour about 1 litre of water into the detergent dispenser to reactivate the “Eco System”. 31 CARE AND MAINTENANCE APPLIANCE EXTERIOR AND CONTROL PANEL • • Clean using normal household cleaner (do not use abrasive products). Disengage the detergent dispenser by pressing the release lever in the prewash compartment and extract it. [. . . ] Install the cover panel following the relative instructions. Refit the fixing screws and tighten them. BUILD-UNDER OPENING DIMENSIONS Width Height Depth 600 mm 825 mm 600 mm WARNING: Only plug the appliance into the mains power socket after you have fitted the cover panel or the appliance worktop. 36 INSTALLATION INSTRUCTIONS WATER SUPPLY • • • Water supply: cold water only Tap: 3/4” threaded hose connection Pressure: 100-1000 kPa (1-10 bar). WATER INLET HOSE 1. Carefully screw the hose connection onto the tap preferably by hand. Make sure there are no kinks in the hose. [. . . ]