User manual WHIRLPOOL WA ECOSTYLE 90 PROGRAM CHART

[. . . ] Curtains and delicate clothing, dresses skirts, shirts and blouses. Only woollens, labelled with the Woolmark and identified as machine washable. This programme (40°C) is tested and approved by The Woolmark Company for machine washable wool. Textiles made of silk, linen, wool and viscose marked as “handwashable”. [. . . ] The light of the “Start (Pause)” button stops blinking and is on; the light of the start delay button will keep blinking until the programme starts. • As soon as the programme starts, the start delay on the display is replaced by the remaining programme time, and the light of the “Start delay” button goes off. • Once having pressed the “Start (Pause)” button, the number of hours preselected can be changed by pressing and holding the “Start delay” button. To cancel the “Start delay” . . before you press “Start (Pause)”: • Turn the programme selector to another position or press the “Reset/Drain” button. . . after having pressed “Start (Pause)”: • Press “Start (Pause)” - the delay time disappears from the display; press “Start (Pause)” again to start the selected programme immediately. “DOOR OPEN” INDICATION Before starting and after end of a programme, the lamp lights to show that the door can be opened. As long as a wash programme is running, the door remains locked and must on no account be forced open. In case you have an urgent need to open it during a running programme, refer to “Reset a running programme before the end”. RED INDICATIONS “Service” Lighting up of the “Service” indication can be caused by a fault in an electrical component. Refer to the “Troubleshooting Guide” in your Instructions for Use; if the fault persists, contact our After Sales Service. “Water tap closed” The appliance has no or insufficient water supply. Open the water tap; if the indication still lights up, refer to the “Troubleshooting Guide” in the Instructions for Use. “Clean pump” Waste water is not pumped out. Check whether the drain hose is kinked or the filter must be cleaned; in the latter case refer to the Instructions for Use (“Removing the Filter”). Consumption values were measured in normalized conditions in compliance with Standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. * The time indicated on the display can deviate from the values in the table, because it takes into account the operation conditions applicable at that time. ** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. *** Reference Programme for Energy Label (with separator in dispenser removed for powder detergent use). ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Load your laundry, close the door properly and add detergent as indicated on the front page and as described in the chapter “Detergent and Additives” in your Instructions for Use (remove separator in detergent dispenser for use of powder detergent if necessary). Turn the programme selector to the desired programme. The display shows the programme duration in hours and minutes as well as the predefined temperature. The “Start (Pause)” button blinks. The temperature can be altered by pressing the “Temperature” button. The indication lamp of the predefined spin speed lights up; in case you want to set another spin speed, press the “Variable spin” button. SELECT ANY DESIRED OPTION Push the button(s) of any option(s) desired - the respective indication lights up. When the combination of programme and option is not possible, the lights switch off automatically. [. . . ] • Press the button to set another spin speed. • If you select spin speed “0”, the final spinning is cancelled but intermediate spin peaks remain during rinse. The water is drained out only. PROGRAMME END • The display shows “End” and the “Door open” indication lights. Turn the programme selector to the “Off/O” position. [. . . ]