User manual WHIRLPOOL WA PLUS 634 A INSTRUCTION FOR USE

[. . . ] Woollens, labelled with the Woolmark and identified as machine washable, as well as textiles made of silk (keep to care label!), linen, wool and viscose marked as handwashable. This programme, at 40°C, is tested and approved by The Woolmark Company for machineand handwashable wool. Normally to heavily soiled and robust white cotton laundry. Save energy by selecting a lower wash temperature and adding an oxygen-based bleach product, in addition to your detergent. [. . . ] As long as a wash programme is running, the door remains locked and must on no account be forced open. In case you have an urgent need to open it during a running programme, refer to “Reset a running programme before the end”. SET CYCLE END (“FINISH IN”) Consumption values were measured in normalized conditions, in compliance with IEC/EN 60456. In the home, they may vary depending on the individual water supply pressure and temperature, the load and the type of wash. The consumption data indicated are based on an inlet water temperature of approx. 15°C through the cold fill valve as well as the hot fill valve (if available). If your washing machine has a hot fill valve, connection of this valve to hot water supply will lower the energy consumption by reduced heating times, depending on the individual hot fill inlet water temperature. Water and energy consumptions refer to the default setting of the programmes, with temperature and load as indicated in the table; selecting any options or changing the spin speed will also change the consumption data. The programme duration may differ from the values indicated above as it depends on the operation conditions applicable at that time (see also “Troubleshooting Guide” in your Instructions for Use). * ** *** Reference programmes for Energy Label. To reduce the water temperature, some cold water is added at the end of the main wash cycle before the water is drained. Automatic adaptation of programme duration after detection of wash load. LOAD LAUNDRY, ADD DETERGENT AND SELECT THE PROGRAMME Load the laundry, close the door and add detergent as indicated on the front page and as described in the chapter “Detergent and Additives” in your Instructions for Use. Turn the programme selector to the desired programme and temperature. The display shows the programme duration and the predefined spin speed. The “Start/Pause” indicator blinks. • • your detergent (only use powder detergent with this option). Respect the manufacturer’s dosing instructions. May prolong the programme by up to 15 minutes. Appropriate for use of stain removers and bleaches on oxygen basis. Chlorine or perborate bleaches must not be used! “15° Green & Clean” button • • • • • Enables ecological washing by saving energy used for waterheating, while maintaining a good wash result. Bright colours live longer with this option; this was tested and approved by the German “wfk” laundry research institute. Recommendable for lightly soiled laundry without stains. Make sure that your detergent is suitable for cold wash temperatures (15 or 20°C). Not selectable for Cotton 95°C. SELECT ANY DESIRED OPTION Push the button of any option desired - the indicator lights up. [. . . ] Spin speed on display blinks: unbalance during spinning. PROGRAMME END • 1. The “Door open” indicator lights up, and the display shows “End”. Turn the programme selector to the “Off/O” position. Leave the door ajar to allow the drum to dry. CHANGE PROGRAMME AND/OR OPTIONS AFTER PROGRAMME START 1. [. . . ]