User manual WHIRLPOOL WA PLUS 726 BW INSTRUCTION FOR USE

[. . . ] DEFINITION OF USE This washing machine is exclusively destined to wash and spin machine washable laundry in quantities which are usual for private households. €¢ Observe the instructions given in these Instructions for Use, the Installation Guide and the Programme Chart when using the washing machine. €¢ Keep these Instructions for Use, the Programme Chart and the Installation Guide; if you pass on the washing machine to another person, also give him/ her Instructions for Use, Programme Chart and Installation Guide. Removing the packaging and inspection • After unpacking, make sure that the washing machine is undamaged. [. . . ] - half load: 3/4 the amount used for a full load. - minimum load (about 1 kg): 1/2 the amount used for a full load. If there is no reference to a certain wash load on the detergent pack: the detergent manufacturers usually refer their dosing recommendations to 4. 5 kg laundry for heavy duty detergent and 2. €¢ water hardness in your area (ask for information from your water company). Soft water requires less detergent than hard water. Please note: Too much detergent can result in excess foam formation, which reduces washing efficiency. If the washing machine detects too much foam, it may prevent spinning, or prolong the programme duration and increase the water consumption (see also remarks on foam formation in the “Troubleshooting Guide”). - Remove the plinth by using the siphon of the detergent dispenser: push downwards one side of the plinth with your hand, then push the siphon’s nose into the gap between plinth and front panel and pry open the plinth (picture “B”). - If there is no emergency drain hose: place a broad, flat container beneath the filter (picture “D”). Hold the emergency hose’s end into the container and remove the stopper (picture “C”). Wait until all the water has drained, then refix the stopper at the hose’s end (picture “E”). Refix the emergency drain hose to the clip, or push it back into the washing machine’s base (depending on the model). A towel) on the floor in front of the filter. Slowly open the filter by turning it counter-clockwise (picture “F”); wait until all the water has drained, then unscrew the filter completely and remove it. Tilt the appliance forwards carefully (a second person must help you) to allow the water to flow out completely. Clean the filter and the filter chamber; check that the pump rotor in the filter chamber moves freely. Reinsert the filter and screw it in clockwise as far as it will go. Pour about 1 litre of water into the detergent dispenser to reactivate the “Eco system”. Check that the filter is inserted properly and securely and no water comes out. Reinstall the plinth (picture “G”); if necessary, tilt the washing machine slightly backwards for doing that (a second person must help you). GB 6 A B C D E F G CARE AND MAINTENANCE Appliance exterior and control panel • Wash down with a soft, damp cloth; if necessary use a neutral detergent (non abrasive). [. . . ] If the washing machine continues to function incorrectly, call our After-Sales Service. The After-Sales Service sticker can be found inside the door. €¢ Your telephone number and area code. After-Sales Service phone numbers and addresses are given on the guarantee card. [. . . ]