User manual WHIRLPOOL WA PURE XL 24 BW B INSTRUCTION FOR USE

[. . . ] Same as the spin cycle in the “Cotton” programme. €” ❉: 1) optional / Yes : dosing required For improved garment care, spin speed is restricted in these programmes. The wool and handwash cycles of this machine have been tested and approved by The Woolmark Company for the washing of Woolmark garments labelled as “machine wash” or “hand wash” provided that the garments are washed according to the instructions on the garment label and those issued in this programme chart. Fm Page 2 Tuesday, May 18, 2010 5:24 PM CONSUMPTION DATA Programme White Cotton / Hygienic+ Cotton Cotton SuperEco Synthetics Synthetics Daily load Quick wash Jeans Delicates Wool Handwash / Lingerie Handwash / Lingerie Eco Cotton*** Temperature (°C) 95 60 40 60 60 40 40 30 40 30 40 40 30 60 Load (kg) 6. [. . . ] If the indication still lights up, refer to the “Troubleshooting Guide” in your Instructions for Use. “Clean pump” Waste water is not pumped out. Check whether the drain hose is kinked or the filter must be cleaned. In the latter case refer to the Instructions for Use (“Removing the Filter”). Consumption values were measured in normalized conditions in compliance with Standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. The time indicated on the display can deviate from the values in the table, because it takes into account the household conditions applicable at that time. * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ** *** Reference Programme for Energy Label. START DELAY The “Start delay” allows to run the machine at the consumer’s convenience, for example at night when electricity is cheaper. Do not use liquid detergent when activating the “Start delay”. Choose temperature of 30 or 40°C and use with maximum load. €¢ Add an appropriate amount of in-wash additive for stain removal (powder) to the main wash chamber, together with your detergent (only use powder detergent with this option). €œPrewash” button • Only for heavily soiled loads (for example sand, granular dirt). Increases the cycle time by approximately 15 min. €¢ Do not use liquid detergent for the main wash when activating the Prewash option. €œRinse hold” button • The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from changing. €¢ It is particularly useful if you want to postpone spinning to a later time, or if you want to drain only. €¢ If you select “Rinse hold”, do not leave the laundry to soak for too long. Note: The programme stops to “Rinse hold” at the time the “Rinse hold” light in the programme sequence indicator is on. The indication lamp next to the “Start” button blinks. Terminate the “Rinse hold” option : • Press the “Start” button . [. . . ] Select the new programme, temperature, any options and another spin speed if you want. press the “Start” button again. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. [. . . ]