User manual WHIRLPOOL WA STAR 70 EX BK INSTALLATION

[. . . ] - Keep the transport bolts and the wrench for further transporting of the appliance; in this case refit the transport bolts in reverse order (for “Version II” see additional instructions under 2 . Unscrew the 4 screws with the wrench supplied. Move the screws to the center of the holes Pull out the screws together with the black and remove them. [. . . ] Important: Tighten the locknut by turning it anti-clockwise towards the appliance casing. If the water inlet hose is not already installed, it must be screwed to the appliance. Screw by hand the inlet hose onto the tap tightening the nut. attention: • no kinks in the hose!€¢ The appliance must not be connected to the mixing tap of an un-pressurized water heater. €¢ Check water-tightness of connections by turning the tap completely on. attention: • no kinks in the hose!€¢ Check the inlet hose regularly for brittleness and cracks and replace if necessary. €¢ The washing machine can be connected without a non-return valve. attention: • no kinks in the hose!This replacement is only to be carried out by a trained electrician. Depending on the model, the inlet hose and the plastic enclosure at the tap connection contain electrical components. Do not cut the hose and do not immerse the plastic enclosure in water. Isolate the appliance from the mains immediately if the hose is damaged. In case the drain hose is installed as shown on the models below: Unclip it from the holders marked with arrows. In case the drain hose is installed in the upper part of the washing machine: Unclip it from both holders marked by the arrows (see below, depending on the model). [. . . ] €¢ To make an extension, use a hose of the same type and secure the connections with clips. Overall drain hose length: 2, 50 m (in this case, the maximum height for fixation see picture below - is 90 cm). do not use extension leads or multi sockets. [. . . ]