User manual WHIRLPOOL WA UNIQ 814 ST PRODUCT FICHE

[. . . ] This programme is tested and approved by The Woolmark Company for machine- and handwashable wool. Select spin speed according to the manufacturer’s recommendations on the care label. Normally soiled cotton jeanswear and garments made of robust jeanslike material such as trousers and jackets. Normally to heavily soiled and robust white cotton laundry. Save energy by selecting a lower wash temperature and adding an oxygen-based bleach product, in addition to your detergent. [. . . ] Programme Duration (hours : minutes)* 1:00 2:10 2:20 2:05 1:35 1:20 0:45 0:40 2:21 2:20 1:20 1:40 4:00 1:00 0:15 4:00 START DELAY The “Start delay” allows to run the machine at the consumer’s convenience, for example at night when electricity is cheaper. Do not use liquid detergent when activating the “Start delay”. • Select programme, temperature and options. • Press the “Start delay” button to select a delay time up to 23 hours. The light of the “Start (Pause)” button blinks. • Press the “Start (Pause)” button . The light of the “Start (Pause)” button stops blinking and is on. The light of the start delay button will keep blinking until the programme starts. • As soon as the programme starts, the start delay on the display is replaced by the remaining programme time, and the light of the “Start delay” button goes off. • Once having pressed the “Start (Pause)” button , the number of hours preselected can be changed by pressing and holding the “Start delay” button. To cancel the “Start delay” . . . before you press “Start (Pause)” : • Turn the programme selector to another position or press the . Unsuitable combinations of options are deselected automatically. “Clean +” button • Choose this option if you use an in-wash additive for stain removal (powder, for example “Vanish”) - it will optimize the additive’s efficiency to get better wash performance and stain removal. • Choose temperature of 30 or 40°C and use with maximum load. • Add an appropriate amount of in-wash additive for stain removal (powder) to the main wash chamber, together with your detergent (only use powder detergent with this option). Respect the manufacturer’s dosing instructions. • Prolongs the programme by approx. • Appropriate for use of stain removers and bleaches on oxygen basis. Chlorine or perborate bleaches must not be used! “Prewash” button • Only for heavily soiled loads (for example sand, granular dirt). Increases the cycle time by approximately 15 min. • Do not use liquid detergent for the main wash when activating the Prewash option. “Intensive rinse” button • More water is added and rinse cycle is prolonged. [. . . ] Due to variations in load and temperature of inlet water, the remaining time is newly calculated in certain programme phases. If this is the case, an animation appears on the display. DETERGENT OVERDOSAGE INDICATION In case you used too much detergent, a small vertical bar will light next to the overdosage symbol on the right of the display when the wash programme is finished. Too much foam by detergent overdosing can also lead to interruption of a wash cycle. In this case the display shows “Fod” - follow the recommendations in the “Troubleshooting Guide” in your Instructions for Use to solve the problem. CHILD LOCK Activating the child lock prevents children from starting a wash cycle or changing the settings of a running programme. [. . . ]