User manual WHIRLPOOL WAE 8573 PROGRAM CHART

[. . . ] spin speed Notes Start delay Prewash Départ différé h Prélavage Rinçage Plus Arrêt cuve pleine rpm 1200 “Prewash” can be additionally selected for heavily soiled laundry. h h Yes h h h h h h h h h h h h h h 5. 0 Yes 1200 “Prewash” can be additionally selected for heavily soiled laundry. Synthetics Synthétiques Delicate Délicat Wool Laine Rapid wash Chrono Hand wash Lavage main Rinse + Spin Rinçage + Essorage Intensive spin Essorage Long Gentle spin Essorage court Draining / Clearing Vidange / R. A. Z. 1) 2) 2. 5 h h h h h h Yes h h h h h h h h h h h h h h h h h h h h h 1) h 1) h 1) h h 2) h h h 1) h 20 to 60 20 to 40 20 to 40 20 to 60 20 to 30 20 1000 1) “Prewash” can be additionally selected for heavily soiled laundry. In this programme, selection of the special options “Intensive Rinse” and “Easy ironing” is not possible. If you select “Rinse Hold” do not leave items to soak for too long. In this programme, selection of the special options “Prewash”, “Intensive Rinse” and “Easy Ironing” is not possible. [. . . ] After the end of a programme phase the associated indicator light goes out. Thus the programme sequence indicator moves from left to right across the wash, rinse and spin phases. At the end of the programme only the “End” indicator is still on. DOOR LOCK In the first 15 minutes after the start of the “Cotton”, “Cotton coloured” and “Synthetic” programmes the door can be opened to add further laundry. This is not possible if “Rapid Wash” is selected. PROGRAMME END • The remaining time display shows “0:00” and three short signals sound. Turn the programme selector knob to the “Off” position. RESELECT AFTER PROGRAMME START A newly-selected programme will continue in the same programme section during which the current programme was interrupted. Therefore do not add any more detergent. Press the “Start/Pause” button to interrupt the programme. Select the new programme (with temperature), any additional options and - if you wish - another spin speed. Press the “Start/Pause” button again to restart the programme. • If you are in the “Prewash” programme step this additional option can not be deselected as described (to do this see “Interrupt/Cancel Programme”). Press the “Start/Pause” button to interrupt the programme. Set the programme selector to “Drain/ Cancel”. The spin speed “0” and the remaining time “2 minutes” are displayed. Press the “Start/Pause” button to start the “Drain/Cancel” programme. The “Start Delay” allows to run the machine at the consumer’s convenience, for example at night when electricity is cheaper. * Consumptionvalues were measured in normalized conditions in compliance with Standard IEC 60456. ** The programme duration may also vary from the chart values. The washing machine is able to allow for • Press the “Start Delay” button. Select the particular household conditions and to adapt the programme run time accordingly. programme start from 1 to 19 hours ***To reducethe water temperature, some cold wateradded at the end of the main wash cycle, is ahead by pressing the button again. [. . . ] the “+” or “-” button under the Note: The programme has reached the To increase the number of hours corresponding LED display. “Rinse Hold” when the “Rinse Hold” button preselected, first turn the programme light flashes. selector switch to the “Off” position. Then SELECT SPECIAL OPTIONS - The Terminate the “Rinse Hold” option: set the programme and the additional indicator lights go on. [. . . ]