User manual WHIRLPOOL WAK 1200 P INSTRUCTION FOR USE

[. . . ] Contents Before Using The Washing Machine Precautions and General Recommendations Description Of The Washing Machine Door Child Safety Before The First Wash Cycle Preparing The Wash Detergent And Additives Removing The Filter Draining Residual Water Care And Maintenance Troubleshooting Guide After-Sales Service Transport/Handling 16 Before Using The Washing Machine 1. Remove the packaging and check • After unpacking, make sure that the washing machine is undamaged. If in doubt, do not use the washing machine. Contact After-Sales Service or your local retailer • Check that the accessories and supplied parts are all present • Keep the packing material (plastic bags, polystyrene parts, etc. ) out of reach of children, as they are potentially dangerous 2. [. . . ] buttons, coins or safety pins) IMPORTANT: make sure the water has had time to cool before draining the appliance. Open the filter cover with the help of the coloured insert from the detergent container. Open the filter but do not withdraw it completely. Slowly turn the handle anticlockwise until the water drains out. Wait until all the water has drained off. Now unscrew the filter completely and remove it. Clean the filter and the filter chamber. Insert the filter with the guide pin upwards and screw it in clockwise to the stop (handle horizontal). Pour about 1 litre of water into the detergent drawer to reactivate the Eco system. Check that the foreign body trap is seated properly and tightly in place. Select a programme and start it. Draining Residual Water Before emptying the residual water, switch the appliance off and unplug it from the mains socket. Open the cover to the foreign body trap. Open the filter cover with the help of the coloured insert from the detergent container. Open the filter but do not withdraw it completely. Slowly turn the handle anticlockwise until the water drains out. Wait until all the water has drained off. Now unscrew the filter completely and remove it. Tilt the appliance forwards carefully to allow the water to flow out. This enables faults to be detected in good time and the safety system can react appropriately. These faults are frequently so minor that they can be removed within a few minutes. The appliance will not start, no lamp lights up. Check whether: • the mains plug is inserted into the socket • the wall socket is functioning correctly (use a table lamp or similar) to test the washing machine will not start. . . [. . . ] For models with a fault display, the “Water Stop” indicator lights up and the spin speed indicator LEDs flash. If a digital display is fitted, “A” and “F” are also displayed alternately. For models with no fault display, the washing machine stops in the appropriate programme step. Switch the appliance off, pull out the mains plug and turn the water tap off. [. . . ]