User manual WHIRLPOOL WAK 6760 INSTRUCTION FOR USE

[. . . ] 40105150aGB. fm Page 18 Wednesday, November 17, 2004 4:59 PM CONTENTS BEFORE USING THE WASHING MACHINE PRECAUTIONS AND GENERAL RECOMMENDATIONS DESCRIPTION OF THE WASHING MACHINE DOOR CHILD SAFETY BEFORE THE FIRST WASH CYCLE PREPARING THE WASH DETERGENT AND ADDITIVES REMOVING THE FILTER DRAINING RESIDUAL WATER CARE AND MAINTENANCE TROUBLESHOOTING GUIDE AFTER-SALES SERVICE TRANSPORT/HANDLING ELECTRICAL CONNECTION 18 Black process 45. 0° 100. 0 LPI 40105150aGB. fm Page 19 Wednesday, November 17, 2004 4:59 PM BEFORE USING THE WASHING MACHINE 1. Remove the packaging and check • After unpacking, make sure that the washing machine is undamaged. If in doubt, do not use the washing machine. Contact After-Sales Service or your local retailer • Check that the accessories and supplied parts are all present • Keep the packing material (plastic bags, polystyrene parts, etc. ) out of reach of children, as they are potentially dangerous 2. [. . . ] Now unscrew the filter completely and remove it. Clean the filter and the filter chamber. Insert the filter with the guide pin upwards and screw it in clockwise to the stop (handle horizontal). Insert the detergent dispenser in the washing machine. Mesh Filters in the Water Connection Check and clean regularly. For washing machines with a straight inlet hose 1. Turn off the tap and unscrew the water inlet hose from the tap. Clean the internal mesh filter and screw the water inlet hose back onto the tap. Now unscrew the inlet hose on the rear of the washing machine. Pull off the mesh filter from the washing machine connection with universal pliers and clean it. Refit the mesh filter and screw the inlet hose on again. Turn on the tap and ensure that the connections are completely watertight. For washing machines with Water Stop hose 1. Turn off the tap and unscrew the Water Stop hose from the tap. Clean the internal mesh filter and screw the water inlet hose back onto the tap. Turn on the tap and ensure that the connection is completely water-tight. 26 Black process 45. 0° 100. 0 LPI 40105150aGB. fm Page 27 Wednesday, November 17, 2004 4:59 PM TROUBLESHOOTING GUIDE Depending on the model, your washing machine is equipped with various automatic safety functions. This enables failures to be detected in good time and the safety system can react appropriately. These failures are frequently so minor that they can be removed within a few minutes. The appliance will not start, no lamp lights up. Check whether: • the mains plug is inserted into the socket • the wall socket is functioning correctly (use a table lamp or similar to test) the washing machine will not start. . . and the “Start/Pause” light flashes. Check whether: • the appliance door is properly closed (child safety); • The “Start/Pause” button has been pressed In the case of washing machine with LCD this notice appears: Detergent and additive product residues in dispenser at end of wash. Check whether: • the siphon is correctly installed and cleaned (see “Care And Maintenance”) • sufficient water is entering. [. . . ] For models with failure display, select and start the desired programme again. If the failure occurs again, please contact After Sales Service (see “After-Sales Service”). “Water Stop” failure when the programme selector switch marking is on top (“Off” position). The pump is switched on automatically in order to pump the water out. [. . . ]