User manual WHIRLPOOL WAK 7269 PRIMELINE INSTRUCTION FOR USE

[. . . ] CONTENTS BEFORE USING THE WASHING MACHINE PRECAUTIONS AND GENERAL RECOMMENDATIONS DESCRIPTION OF THE WASHING MACHINE DOOR CHILD SAFETY (IF AVAILABLE) BEFORE THE FIRST WASH CYCLE PREPARATION OF THE WASHING DETERGENTS AND ADDITIVES REMOVING THE FILTER DRAINING RESIDUAL WATER CARE AND MAINTENANCE TROUBLESHOOTING GUIDE AFTER-SALES SERVICE ACCESSORIES TRANSPORT / HANDLING ELECTRICAL CONNECTION BEFORE USING THE WASHING MACHINE 1. Removing the packaging and inspection • After unpacking, make sure that the washing machine is undamaged. If in doubt, do not use the washing machine. Contact After-Sales Service or your local retailer. • Check that the accessories and supplied parts are all present. [. . . ] • To prevent dispensing problems when using highly concentrated powder and liquid detergents, use the special detergent ball or bag supplied with the detergent and place it directly inside the drum. Open the filter but do not remove it completely. Slowly turn the filter counterclockwise until the water begins to drain out. Now unscrew the filter completely and remove it. Tilt the appliance forwards carefully to allow the water to flow out. Re-insert the filter and screw it in clockwise as far as it will go. Before using the washing machine again: 1. 1 litre of water into the detergent drawer to reactivate the “Eco system”. 25 CARE AND MAINTENANCE Appliance exterior and control panel • Can be washed down with a soft, damp cloth. • A little neutral detergent (non abrasive) can also be used. • Dry with a soft cloth. Door seal • Clean with a damp cloth when necessary. • Check the condition of the door seal periodically. Filter • Check and clean the filter regularly, at least two or three times a year (see “Removing the filter”). Do not use flammable fluids for cleaning the appliance. Detergent dispenser 1. Press the release lever in the main wash compartment downward and remove the drawer (fig. Remove the cover grid from the fabric softener compartment. Remove the separator from the main wash compartment by pulling it upward (fig. Refit the separator and the grid in the detergent drawer and fit the drawer back inside its housing. A B 26 Water supply hose Check the supply hose regularly for brittleness and cracks and replace it if necessary using a new hose of the same type (available from After-Sales Service or specialist dealer). If your supply hose has a transparent hose coating (fig. “C”), periodically check the colour of the transparent coating. If the coating begins to turn red, this is an indication that the hose may have a leak and should be replaced. Contact our After-Sales Service team or specialist dealer to obtain a replacement hose. A Mesh filter for water connection Check and clean regularly. For washing machines with an inlet hose as shown on pictures “A”, “B” or “C” (depending on the model): 1. Close the tap and loosen the inlet hose on the tap. [. . . ] Restart the programme to check whether the problem has solved itself. If the washing machine continues to function incorrectly, call After-Sales Service. The After-Sales Service sticker can be found inside the door. • Your telephone number and area code. [. . . ]