User manual WHIRLPOOL WAK 9899 PROGRAM CHART

[. . . ] “Door open” indication This washing machine is equipped with automatic safety functions which detect and diagnose faults at an early stage and react appropriately, e. g. : B. “Water tap closed” indication D. “Clean pump” indication Care Labels Max. Load kg with prewash 95 °C 40 - 60 - 95 °C with prewash 60 °C 30 - 40 - 60 °C E. [. . . ] In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme. Same as the spin cycle in the “Wool” programme. Water is drained only - no spinning. Yes – Yes – – – – – – – – – – Yes 1) Yes Yes 1) Yes Yes Yes Yes Yes Yes – – – – i i i i i i i i i i – – – Bomuld Synthetics Synthetics Delicates 30 - 40 °C 30 °C Syntetisk Syntetisk Finvask Quick 30 °C Kold - 40 °C Quick wash Cold - 40 °C Wool 40 °C 30 °C Uld Handwash Lingerie Rinse & Spin Spin Gentle Spin Drain i: 1) 2) Håndvask 40 °C 30 °C Skånevask Skyl & Centrif. Tømning option / Yes : dosing required Do not use liquid detergent for main wash when activating the prewash For improved garment care spin speed is restricted to 400 rpm in this programme. Bauknecht is a registered trademark of Whirlpool USA. 5019 401 01012 CONSUMPTION DATA PROGRAMME START PROGRAMME END Programme Cotton Cotton ** Cotton Synthetics Synthetics Delicates Quick wash Wool Handwash Lingerie Temperature Selector (°C) 95 60 40 60 40 30 30 40 40 30 Load (kg) 5. 0 5. 0 5. 0 2. 5 2. 5 1. 5 3. 0 1. 0 1. 0 1. 0 Water (l) 49 * 44 44 50 * 45 50 40 55 45 45 Energy (kWh) 1. 90 0, 95 0. 60 0. 70 0. 55 0. 50 0. 40 0. 60 0. 60 0. 50 Approx. Programme Duration (hours : minutes) 2:00 2:20 2:00 1:30 1:15 0:45 0:30 0:45 0:40 0:36 Open the tap and press the “Start” button. The indication lamp next to the “Start” button lights up. The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Spin/ Drain. When the programme phrase is finised, the corresponding indication goes out. “DOOR OPEN” INDICATION • All the lights of the programme sequence indicator are off, and the “Door open” indication lights up. Turn the programme selector to the “Off/O” position. Leave the door ajar to allow the drum to dry. CHANGE PROGRAMME AND/OR OPTIONS AFTER PROGRAMME START Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ** Reference Programme for Energy Label. Before starting and after end of a programme, the lamp lights to show the the door can be opened. As long as a wash programme is running, the door remains locked and must on no account be forced open. In case you have an urgent need to open it during a running programme, refer to “Cancel (Reset) a running programme before the end”. RED INDICATIONS ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add detergents as indicated on the front page and as described in your Instructions for Use. Close the door and turn the programme selector to the desired programme and temperature. The indication lamp next to the “Start” button blinks. SELECT ANY DESIRED OPTION “Half load” button • Reduces water consumption, above all during the rinsing. [. . . ] The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. CANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END The “Reset” button cancels a programme before the end. • Press the “Reset” button for at least 3 seconds. Any existing water is drained out before the door can be opened. Push the button(s) of any option(s) desired - the respective indication lamp lights up. [. . . ]