User manual WHIRLPOOL WAT 9545D PROGRAM CHART

[. . . ] 40 Programme Duration (min) * 120 120 89 74 30 45 42 25 Note: The programme stops to “Rinse Hold” at the time the “Rinse Hold” button light flashes Terminate the “Rinse Hold” option: • Press the “Rinse Hold” button again; the programme will terminate automatically with the final spin cycle for the present wash programme. €¢ If you do not wish to spin the clothes, turn the programme knob to the Drain programme “ ” and “Start” again. spin speed reduction button “ ” • Every programme has an automatic predefined maximum spin speed. €¢ Press the button to set another spin speed. [. . . ] *The remaining time indicator can similarly deviate from the values in the table, because it takes into account the household conditions applicable at that time. **To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ADDING DETERGENT AND ADDITIVES Add the detergent and the additives into the dispenser as follows: • • • • Programme with pre and main wash Main wash programme without prewash Fabric softeners and conditioners Stain remover agents PROGRAMME START Open the tap and press the Start/Pause button “ ”. The pilot lamp of the “Start/Pause” button lights up. The indicator lamps show the sequence reached in the programme. After starting the programme, the sequence indication runs from left to right through Wash “ ”, Rinse “ ”, Spin “ ”. When the sequence of the programme is finished the corresponding lamps goes out. €¢ Anti-scale agents (water hardness 4) Important: • Be careful not to fill more than the “MAX” level mark. €¢ For programmes without prewash from cold to 40° C it is recommended to use a liquid detergent to avoid whitish residues on the coloured laundry. €¢ With a Start delay, use a dose aid for liquid detergent, placed directly in the drum. DOOR LOCK During the running programme the door can be opened for adding further laundry. the door locks automatically in all rinsing and spinning cycles. If the programme is stopped or the electrical power supply is terminated, the door lock will open after approximately 1 minute. The remaining time is on “0:00” and all the lights of the programme sequence indication are “Off”. A short audible tone sounds three times. Turn the programme selector to the position “ ”. Open the door and the drum flaps and unload the machine. Press the Start/Pause button “ ” to pause the programme. [. . . ] An audible tone sounds if the combination of programme and additional options is not possible. Unsuitable combinations of options are deselected automatically Prewash button “ ” • Only for heavily soiled loads (for example sand, granular dirt) sensible. The cycle time increases from 5 to 20 min. Intensive Rinse button “ ” • The water level and the cycle time increase for improved rinsing efficiency. [. . . ]