User manual WHIRLPOOL WAT 9558WD PROGRAM CHART

[. . . ] Only machine washable woollens with pure new wool label. If you select the special function “Rinse Hold” do not leave garments to soak for too long. Silk and other textiles, which are labelled with “Handwash”. For improved garment care the spin speed is restricted to 400 rpm. [. . . ] • The number of hours preselected can later be reduced pressing again the “Start Delay” button. To cancel the “Start Delay”. • Turn the programme selector to the “ ” position. • Reselect the desired programme and options and press the “Start/Pause” button. Prewash cycle increases programme duration by 5 to 20 min. Consumption values were measured in normalized conditions in compliance with Standard IEC 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. *The remaining time indicator can similarly deviate from the values in the table, because it takes into account the household conditions applicable at that time. **To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ADDING DETERGENT AND ADDITIVES Add the detergent and the additives into the dispenser as follows: • Programme with pre and main wash • Main wash programme without prewash • Fabric softeners and conditioners • Chlorine bleach • Stain remover agents • Anti-scale agents (water hardness 4) Important: • Be careful not to fill more than the “MAX” level mark. • For programme with prewash: do not use liquid detergents and detergent tablets. • For programmes without prewash from cold to 40° C it is recommended to use a liquid detergent to avoid whitish residues on the coloured laundry. • With a Start delay, use a dose aid for liquid detergent, placed directly in the drum. • Use detergent in the form of tablets placing it directly in the drum, above the laudry, not in the dispenser. PROGRAMME START Open the tap and press the Start/Pause button “ ”. The pilot lamp of the “ ” button lights up. The indicator lamps show the sequence reached in the programme. After starting the programme, the sequence indication runs from left to right through Wash, Rinse, Spin. When the sequence of the programme is finished the corresponding lamps goes out. DOOR LOCK During the running programme the door can be opened for adding further laundry. The door locks automatically in all rinsing and spinning cycles. If the programme is stopped or the electrical power supply is terminated, the door lock will open after approximately 1 minute. PROGRAMME END • 1. The remaining time is on “0:00” and all the lights of the programme sequence indication are “Off”. A short audible tone sounds three times. Turn the programme selector to the position “ ”. Open the door and the drum flaps and unload the machine. [. . . ] The cycle time increases from 5 to 20 min. “Intensive Rinse” button • The water level and the cycle time increase for improved rinsing efficiency. • This option is particularly suitable for areas with very soft water washing baby linen and helps people with allergies. “Rinse Hold” button • The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from changing. [. . . ]