User manual WHIRLPOOL WAT 95650/1 PROGRAM CHART

[. . . ] Remove the polystyrene cushion (depending on model). Remove the blue protective film from the panel (depending on model). • After unpacking, make sure that the washing machine is undamaged. If in doubt, do not use the washing machine. [. . . ] Set the desired temperature and spin speed. Press the “Favourites” button for about 3 seconds until the statement “MEM” appears on the screen. Press the “Favourites” button to display the settings of the programme you recorded earlier. Select the desired type of wash, temperature and spin speed. Press the “Favourites” button for about 3 seconds as you did originally to record a first tailor-made programme. The new selections you made will replace those of the old recorded programme. You can re-programme your favourite programmes in this way as often as you like. GB 8 CLEANING THE FOREIGN BODY TRAP The appliance is provided with a self-cleaning pump. The foreign body trap keeps objects like buttons, coins, safety-pins etc. Open the foreign body trap cover with a coin. Turn the foreign body trap slowly anti-clockwise until the grip is vertical; do not remove it as yet. Wait until all the water has drained out. Pull the dispenser towards you and remove. A small quantity of water can remain in the dispenser. It is advisable to carry the dispenser in an upright position. You can also remove the siphon caps in the dispenser for cleaning. Replace the siphon caps in the dispenser (if removed). Replace the dispenser by locating the bottom tabs in the door holes and pivot until both of the upper buttons lock. Note: ensure that the detergent dispenser is correctly reinstalled. GB 10 Water inlet hose filter Check and clean regularly (at least two or three times a year). Carefully clean the filter located at the end of hose, without assembling it, for example with a tooth-brush. Note: For machines equipped with hose type “A”, it must not be submerged in water. Screw the flexible hose back onto the tap by hand. Do not use pliers (risk of squashing the joint). [. . . ] • The appliance must not be connected to the mixing tap of a non-pressurized water heater!• The inlet hose and the plastic enclosure contain electrical components: Do not cut the hose and do not immerse the enclosure in water. • If the flexible hose is damaged, unplug the appliance from the mains immediately and replace it. If the flexible hose is too short, replace it with a 3 m Water Stop hose (available from After-Sales Service or from your dealer). [. . . ]