User manual WHIRLPOOL WAT STUTTGART/1 PROGRAM CHART

[. . . ] If you select the special function “Rinse Hold” do not leave garments to soak for too long. Silk and other textiles, which are labelled with “Handwash”. For improved garment care the spin speed is restricted to 400 rpm. For no spin select the option “Rinse Hold”. [. . . ] The “Start Delay” light flashes until the programme starts. • The time delay indication disappears when the programme starts and it’s replaced by the remaining time. • The number of hours preselected can later be reduced pressing again the “Start Delay” button. To cancel the “Start Delay”. • Turn the programme selector to the “ ” position. • Reselect the desired programme and options and press the “Start” button. . spinning cycles. If the programme is stopped or the electrical power supply is terminated, the door lock will open after approximately 1 minute. PROGRAMME END • The remaining time is on “0:00” and all the lights of the programme sequence indication are “Off”. A short audible tone sounds three times. Turn the programme selector to the position “ ”. Open the door and the drum flaps and unload the machine. . 1. 3. Prewash cycle increases programme duration by 5 to 20 min. Consumption values were measured in normalized conditions in compliance with Standard IEC 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. * The remaining time indicator can similary deviate from the values in the table, because it takes into account the household conditions applicable at that time. ** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. SELECTING A NEW PROGRAMME, SPIN SPEED, OPTIONS AFTER PROGRAMME START 1. Press the “Start” button to pause the programme. Select the new programme (with temperature), any options and another spin speed if you want it. Press the “Start” button again. The programme continues at the same position of the programme sequence indication. Do not add detergent for this programme. . ADDING DETERGENT AND ADDITIVES Add the detergent and the additives into the dispenser as follows: • Programme with pre- and main wash • Main wash programme without prewash • Fabric softeners and conditioners • Chlorine bleach • Stain remover agents • Anti-scale agents (water hardness 4) Important: • Be careful not to fill more than the “MAX” level mark. • For programmes without prewash from cold to 40° C it is recommended to use a liquid detergent to avoid whitish residues on the coloured laundry. • With a Start delay, use a dose aid for liquid detergent, placed directly in the drum. PRESS ANY DESIRED OPTION BUTTON(S). The pilot lamp lights up. [. . . ] The indicator lamps show the sequence reached in the programme. After starting the programme, the sequence indication runs from left to right through Wash, Rinse, Spin. When the sequence of the programme is finished the corresponding lamps goes out. CLOSE THE DOOR AND SELECT THE PROGRAMME 1. Turn the programme selector knob to the desired programme with its predefined temperature. [. . . ]