User manual WHIRLPOOL WAT UNIQ 65 AAA PRODUCT FICHE

[. . . ] e. Remove the blue protective film from the panel (depending on model). • After unpacking, make sure that the washing machine is undamaged. If in doubt, do not use the washing machine. Contact After-Sales Service or your local retailer. [. . . ] Do not use liquid detergents for programmes with prewash. For programmes without prewash and temperatures from cold to 40° C, it is recommended to use liquid detergents to avoid whitish residues on the laundry. 27 Programme Selection Preparation of Wash Cycle 1. Load the machine, close the drum flaps and check that they are properly locked. Add detergents and additives into the dispenser to no more than the “MAX“ level mark. Please refer to “Detergents and additives”. Turn the programme selector knob to the desired programme. Turn the temperature selector knob (if available) to the desired temperature. Press the spin speed reduction button, if desired. Select the desired options as described in the Programme Chart. Programme Start Turn on the tap and press the “On/Off” button. The indicator light of the “On/Off” button lights up. End of Wash Cycle The programme selector knob is in the Stop position “ ”. Press the “On/Off” button to switch off the machine. Note: If there is a power interruption or if the washing machine is disconnected during the cycle, the programme will run again from the point where it was interrupted. Do not use pliers (risk of squashing the joint). Turn on the tap and check that the connections are water-tight. Plug the washing machine back in. A 31 Recovering an object that falls between the drum and the tub If an object accidentally falls between the drum and the tub, you can recover it thanks to one of the removable drum blades: 1. Close the drum flaps and turn the drum a half-turn. Using a spanner, press on the plastic end while sliding the blade from left to right. It will fall into the drum. 6. Open the drum: you can recover the object through the hole in the drum. Refit the blade from inside the drum: Position the plastic tip above the hole on the right side of the drum. Then slide the plastic blade from right to left until it clips. Close the drum flaps again, turn the drum through half a turn and check the positioning of the blade at all its anchorage points. Plug the washing machine in again. 3 4 4 7 Washing machine exterior and control panel • Clean with a soft damp cloth. • If necessary, a neutral household cleaner can be applied (do not use aggressive or abrasive products). Lid seal • Clean from time to time with a damp cloth. Water inlet hose(s) • Check the hose regularly for brittleness and cracks. [. . . ] Periodically check the hose for brittleness and cracks. The washing machine can be connected without a nonreturn valve. For Great Britain & Ireland only (if available): 1. Carefully screw both water inlet hoses: • hot (see A) fill hose, • and cold (see B) fill hose. [. . . ]