User manual WHIRLPOOL WATE 9573/1 PROGRAM CHART

[. . . ] Slightly soiled overalls and sportswear made of cotton, polyester, polyamide and blends with cotton. Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable. If you select “Rinse Hold” do not leave items to soak for too long. Textiles made of silk, linen, wool and viscose marked as “handwashable”. [. . . ] • If you do not wish to spin the clothes, turn the programme selector knob to the “Drain” programme and press the “Start/ Pause” button again. “Spin Speed Reduction” button • Every programme has an automatically allocated maximum spin speed. • Press the button to set another spin speed. • If you want to cancel the final spin, select the rinse hold option and drain the water after the cycle has finished (see Appliance in “Rinse Hold”). DOOR LOCK For safety reasons, the door is locked during certain phases of the cycle. At the end of the cycle or during an interruption, the door unlocks automatically after about 1 minute. END OF WASH CYCLE • The remaining time is on “0:00” and all the lights of the programme sequence indication are off. Turn the programme selector to the “ ” position. Open the door and the drum flaps and unload the machine. START DELAY The “Start Delay” button allows the user to run the machine at his convenience, for example at night when electricity is cheaper. • Select programme, temperature and options. • Press the “Start Delay” button several times to select the delay time by 1 to 19 hours; • Press the “Start/Pause” button. The indicator light of the “Start/Pause” button lights up and the lamp of the “Start Delay” button flashes. • The time delay indication disappears when the programme starts and is replaced by the remaining time. • The number of hours preselected can be reduced later by pressing the “Start Delay” button again. To cancel the “Start Delay” option • Turn the programme selector to the “ ” position. • Reselect the desired programme and options and press the “Start/Pause” button. CHANGE THE PROGRAMME OR OPTIONS DURING THE CYCLE 1. Select the new programme using the programme selector. If necessary, select the additional options and the spin speed. The luminous indicator of the “Start/Pause” button flashes. Note: the “Start Delay” and “Prewash” options cannot be selected after a programme change. Press the “Start/Pause” button. The new programme selected continues at the same position where the previous programme was interrupted. Note: Do not add detergent for this programme. PREPARATION OF WASH CYCLE 1. Close the drum flaps and check that they are properly locked. [. . . ] Note: The programme stops to “Rinse Hold” when the “Rinse Hold” light indicator programme is on during the cycle. PAUSE/INTERRUPT A PROGRAMME If, for any reason, you wish to interrupt the programme for a certain time and continue it later: 1. Press the “Start/Pause” button. After the desired pause, press again on the “Start/Pause” button. PROGRAMME START Turn on the tap and press the “Start/Pause” button. The indicator light of the “Start/ Pause” button lights up. [. . . ]