User manual WHIRLPOOL WATE 9600 PRODUCT FICHE

[. . . ] e. Remove the blue protective film from the panel (depending on model). • After unpacking, make sure that the washing machine is undamaged. If in doubt, do not use the washing machine. Contact After-Sales Service or your local retailer. [. . . ] For programmes without prewash and temperatures from cold to 40° C, it is recommended to use liquid detergents to avoid whitish residues on the laundry. Programme Selection Select the programme 1. Turn the programme selector knob to the desired programme. The remaining time display (depending on the model) shows the approximate duration of the chosen programme (in hours and minutes) and the pilot lamp of the “Start/Pause” button flashes. The readout of temperature and predefined spin speed corresponding to the selected programme is displayed. The preselected temperature can be altered by pressing the “+” or “-” button. Select an option When you select an option, the corresponding indicator lamp lights up, unless the combination of the programme, the additional options and the temperature is not possible. In this case, an audible signal sounds. 27 Start Delay (depending on model) The “Start Delay” is an option which delays the start of the programme at the consumer’s convenience and enables the use of off-peak electricity (for example late at night). Select programme, temperature and options. • Press the “Start Delay” button to select the delay time of 1 to 19 hours; Programme start Turn on the tap and press the “Start/Pause” button. The indicator light of the “Start/ Pause” button lights up. • Press the “Start/Pause” button. The indicator light of the “Start/Pause” button lights up and the lamp of the “Start Delay” button flashes. Pull the dispenser towards you and remove. A small quantity of water can remain in the dispenser. It is advisable to carry the dispenser in an upright position. You can also remove the siphon caps in the dispenser for cleaning. Replace the siphon caps in the dispenser (if removed). Replace the dispenser by locating the bottom tabs in the lid holes and pivot until both of the upper buttons lock. Note: ensure that the detergent dispenser is correctly reinstalled. 30 Water inlet hose filter Check and clean regularly (at least two or three times a year). Carefully clean the filter located at the end of hose, without disassembling it, for example with a tooth-brush. Note: For machines equipped with hose type “A”, it must not be submerged in water. Screw the flexible hose back onto the tap by hand. Do not use pliers (risk of squashing the joint). [. . . ] Loosen the locknut using the wrench provided. Retighten the locknut by turning it anti-clockwise. Make sure that all feet are resting correctly on the floor and that the appliance is perfectly level and stable (use a spirit level). The appliance can be installed in an area 40 cm wide and 63 cm deep. Note: if you install the machine on thick carpet, adjust the feet to ensure that there is sufficient space under the machine for the air to circulate. Connect the water inlet hose. 1. [. . . ]