User manual WHIRLPOOL WATE 9775 PROGRAM CHART

[. . . ] Shortly worn outer clothing made of cotton, polyester, polyamide and blends with cotton. Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable. If you select “Rinse Hold” do not leave items to soak for too long. Textiles made of silk, linen, wool and viscose marked as “handwashable”. [. . . ] Open the lid and the drum doors and unload the machine. ” position. Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. The data on the “Energy Label” refer to the programme “Cotton 60° C”. * The remaining time indicator can similarly deviate from the values in the table, because it takes into account the household conditions applicable at that time. ** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. START DELAY The “Start Delay” button allows the user to run the machine at his convenience, for example at night when electricity is cheaper. • Select programme, temperature and options. • Press the “Start Delay” button several times to select the delay time by 1 to 19 hours; • Press the “Start/Pause” button. The indicator light of the “Start/Pause” button lights up and the lamp of the “Start Delay” button flashes. • The time delay indication disappears when the programme starts and is replaced by the remaining time. • The number of hours preselected can be reduced later by pressing the “Start Delay” button again. To cancel the “Start Delay” option • Turn the programme selector to the “ ” position. • Reselect the desired programme and options and press the “Start/Pause” button. CHANGE THE PROGRAMME OR OPTIONS DURING THE CYCLE 1. Select the new programme using the programme selector. If necessary, select the additional options and the spin speed. The luminous indicator of the “Start/Pause” button flashes. Note: the “Start Delay” and “Prewash” options cannot be selected after a programme change. Press the “Start/Pause” button. The new programme selected continues at the same position where the previous programme was interrupted. Note: Do not add detergent for this programme. PREPARATION OF WASH CYCLE 1. Close the drum doors and check that they are properly locked. [. . . ] Note: The programme with “Rinse Hold” stops when the “Rinse Hold” indicator light flashes on the “Programme Sequence Indicator”. PAUSE/INTERRUPT A PROGRAMME If, for any reason, you wish to interrupt the programme for a certain time and continue it later: 1. Press the “Start/Pause” button. After the desired pause, press again on the “Start/ Pause” button. CANCEL PROGRAMME 1. Set the programme selector to “Drain/Cancel”. [. . . ]