User manual WHIRLPOOL WATE EXCELLENCE PROGRAM CHART

[. . . ] For heavily soiled laundry the additional “Prewash” option can be selected as well. Normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton. Special Options Temperature Easy Pre- Intensive Rinse Spin Speed Start Ironing wash Rinse Hold Reduction Delay Makkelijk Voor- Intensief SpoelStart seCentrif. lectie uren strijken was Spoelen stop °C 5. 0 ❉ 1) ❉ 1) — ❉ 1) — — Yes ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ — — — ❉ ❉ — ❉ — — ❉ ❉ ❉ — — — ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ 20 to 95 1200 Synthetics Synthetisch 2. 0 Yes — — — — — 20 to 60 1000 2) 30 to 60 1200 Daily Mixed Gemengde was Delicates Rapid Wool Handwash / Lingerie Fijne was Snelwas Wol Slightly to normally soiled textiles made of cotton and/or synthetics Curtains and delicate clothing, dresses, skirts, shirts and blouses. [. . . ] The indicator light of the “Start/Pause” button lights up and the lamp of the “Start Delay” button flashes. • The time delay indication disappears when the programme starts and is replaced by the remaining time. • The number of hours preselected can be reduced later by pressing the “Start Delay” button again. To cancel the “Start Delay” option • Turn the programme selector to the “ ” position. • Reselect the desired programme and options and press the “Start/Pause” button. PROGRAMME START Turn on the tap and press the “Start/Pause” button. The indicator light of the “Start/Pause” button lights up. The indicator lamp shows the sequence reached by the programme. After starting the programme, the programme sequence indicator signals the Wash, Rinse and Spin phases. Note: If there is a power interruption or if the appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted. LID LOCK For safety reasons, the lid is locked during certain phases of the cycle. At the end of the cycle or during an interruption, the lid unlocks automatically after about 1 minute. RED INDICATIONS “Water Stop” Lighting up of the Aquastop indication can be caused by a leak in the appliance or hose. Please refer to the “Troubleshooting Guide” in the Instructions for Use. “Water Tap” The appliance has no or insufficient water supply. Open the water tap; if the indication still lights up, refer to the “Troubleshooting Guide” in the Instructions for Use. END OF WASH CYCLE • The remaining time is on “0: 00” and the “End” lamp lights up. Turn the programme selector to the “ ” position. Open the lid and the drum doors and unload the machine. CHANGE THE PROGRAMME OR OPTIONS DURING THE CYCLE 1. Select the new programme using the programme selector. If necessary, select the additional options and the spin speed. The luminous indicator of the “Start/Pause” button flashes. [. . . ] SELECT THE DESIRED OPTION When you select an option authorized by the programme, the corresponding indicator lights up, except if the combination of programme, additional options and temperature is not possible. “Easy Ironing” button • Can be used together with “Cotton”, “Synthetics” and “Daily Mixed” programmes to make ironing easier. • Increases the water quantity in rinsing and the clothes are spun in a softer manner. “Prewash” button • Only for heavily soiled loads (for example sand, granular dirt). “Intensive Rinse” button • The amount of water is increased to ensure a more intensive rinse. [. . . ]