User manual WHIRLPOOL WATS 5140/S PROGRAM CHART

[. . . ] Spin Speed rpm A B Care Labels Type of wash / Notes C Max. load Prewash Detergents and additives Main Softener Bleach Wash 3) Programme Cotton with prewash Cotone-Colorati con prelavaggio Synthetic with prewash Sintetici con prelavaggio Delicate with prewash Delicati con prelavaggio Cotton Cotone-Colorati normale Cotton short Cotone-Colorati corto Easy Ironing Stiro facile Spin Speed Reduction kg Heavily soiled bed linen, table linen and underwear, towels, shirts etc. Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton. [. . . ] In this programme spinning is intensive. In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme. Same as the spin cycle in the “Wool” programme. Alternative method of terminating programme after “Rinse Hold”. — — ❉ 2) — — N. B. This machine is controlled by sensors. Please avoid excessive detergent dosing. 5019 412 10026 CONSUMPTION DATA Programme Cotton Cotton Cotton Daily Mixed Synthetic Synthetic Delicate Wool Handwash Temperature Selector (°C) 95 60 40 40 60 40 40 40 30 Load (kg) 5. 0 5. 0 5. 0 3. 0 2. 0 2. 0 1. 5 1. 0 1. 0 Water (l) 63* 55 55 45 56 50 60 60 60 Energy (kWh) 1. 80 0. 95 0. 55 0. 45 0. 80 0. 40 0. 55 0. 50 0. 30 Approx. Programme Duration (hours : minutes) 2:05 2:05 2:05 1:00 1:35 1:30 0:50 0:40 0:50 Appliance in “Rinse Hold”: • Press the “Rinse Hold” button again: the programme will terminate automatically with the selected spin cycle. • If you do not wish to spin the clothes, press the “On/Off” button, turn the programme selector knob to the “Drain” programme and press the “On/Off” button again. CHANGE THE PROGRAMME DURING THE WASH CYCLE 1. Switch off the machine by pressing the “On/Off” button. Start programme by pressing the “On/Off” button again. PROGRAMME START Turn on the tap and press the “On/Off” button. The indicator light of the “On/Off” button lights up. Note: If there is a power interruption or if the appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted. PAUSE/INTERRUPT A PROGRAMME If, for any reason, you wish to interrupt the programme for a certain time and continue it later: 1. After the desired pause, press again the “On/ Off” button. Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with standard IEC 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. The data on the “Energy Label” refer to the programme “Cotton 60°C”. * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. END OF WASH CYCLE • The programme selector knob is in the Stop position “ ”. Press the “On/Off” button to switch off the machine. Wait for the door to unlock (about 1 minute). Open the door and the drum flaps and unload the machine. CANCEL PROGRAMME 1. [. . . ] • This option is particularly recommended for the “Synthetic” or “Delicate” programmes. • This function is particularly useful if you want to postpone spinning to a later time, or if you want to drain only. • • • • • • Programme with pre and main wash Main wash programme without prewash Fabric softeners and conditioners Chlorine bleach (4 chamber models only) Stain remover agents Anti-scale agents (if necessary) 3. Turn the programme selector knob to the desired programme. Turn the temperature selector knob to the desired temperature. [. . . ]