User manual WHIRLPOOL WATS 7915 PROGRAM CHART

[. . . ] Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton. Heavily soiled curtains and delicate clothing, dresses, skirts, shirts and blouses. Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. [. . . ] • Start the programme (see next paragraph). As the delay time decreases, the corresponding indicator lamp flashes. • The flashing light of the delay indicator lamp goes out when the programm starts. The delay time can still be modified after the “Start” button has been pressed: To decrease the delay time • (Repeatedly) press the “Start Delay” button. • Note, however, that the selected wash programme starts IMMEDIATELY as soon as you push “Start Delay” with the “1h” lamp flashing. To increase the delay time • Switch the washing machine off by pushing the “On/Off” button. • Turn the programme selector to a different programme. • Switch the washing machine on again by pressing the “On/Off” button. • Reselect the desired programme and options. Select the desired delay time by (repeatedly) pressing the “Start Delay” button. PROGRAMME START Verify that the appliance is switched on. Turn on the tap and press the “Start” button. The indicator lamp of the “Start” button stops flashing and lights up. Note: If there is a power interruption or if the appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted. END OF WASH CYCLE • The “End” lamp of the programme sequence indicator lights up. Press the “On/Off” button to switch off the machine. Wait for the lid to unlock (about 1 minute). Open the lid and the drum doors and unload the machine. Leave the lid open for some time to allow the inside of the appliance to dry. CHANGE THE PROGRAMME DURING THE WASH CYCLE 1. Switch the appliance off by pressing “On/Off”. Turn the programme selector knob to the new programme. Switch the appliance on again by pressing “On/Off”. [. . . ] The option will be applied as long as the corresponding programme phase has not been executed yet. “Eco” button • The duration of the wash is extended and the max temperature reduced to save up to 40% of energy compared to a normal wash but maintaining good washing results. “Intensive Rinse” button • The amount of water is increased to ensure a more intensive rinse. • This option is particularly suitable for areas with very soft water, washing baby linen and people with skin allergies. “Rinse Hold” button • The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from fading. [. . . ]