User manual WHIRLPOOL WBC3535 A NFS PROGRAM CHART

[. . . ] - All shelves and door trays are removable. - The internal temperatures of the appliance depend on the ambient temperature, frequency of opening the doors, as well as location of the appliance. Temperature setting must consider these factors. - The appliance accessories are not suitable for washing in dishwasher. [. . . ] To switch on the fan press the button (1a). It is advisable to activate the fan when the ambient air temperature is over 27 ÷ 28°C or if you perceive drops of water on the glass shelves or in the severe humidity conditions. Note Do not obstruct the air intake area with food items. The fan will run ONLY when the compressor is in operation. Remember to turn off the fan when there is a lower ambient air temperature. If the appliance has the fan it can be equipped with the antibacterial filter. Remove it from the box (found in the crisper drawer (item 7) and insert into the cover of fan (item 1b). The replacement procedure is attached with the filter. DEFROSTING THE REFRIGERATOR COMPARTMENT Refrigerator compartment defrosting is completely automatic. Droplets of water on the rear wall inside the refrigerator compartment indicate that the automatic defrost phase is in progress. The defrost water is automatically run into a drain hole and collected in a container, where it evaporates. DEFROSTING THE FREEZER COMPARTMENT Whirlpool No Frost freezers provide chilled air circulation around the storage areas and prevent the formation of ice, thereby completely eliminating the need for defrosting. Frozen items don't stick to the walls, labeling stays legible and storage space remains neat and clear. D GB F NL E P I GR S N DK FIN PL CZ SK H RUS BG RO PRODUCT SHEET REPLACING THE LIGHT BULB Always disconnect the refrigerator from the power supply before replacing any light bulb. If the inside light is not working, it is necessary to: 1. Remove the light cover: put the fingers into the side ventilation holes (1), stretch the cover gently and move it upwards. If necessary unscrew the broken bulb and replace it with the new one (use maximum 15W bulb). GUIDE TO SELECTING FUNCTIONS Functions and settings Temperature setting button is used to select the fridge/freezer temperature set-point from among 5 levels (level 1, level 2, level 3, level 4, level 5) by consecutive pressing the button. Alarm deactivation - the user has to press Stand-by / Stop alarm pushbutton. Super Freezing: for more efficient freezing activate this function 48 hours before freezing fresh products. - Select Freezer compartment by using button (1), lamp (2) shall turn ON. [. . . ] "6th Sense" function The "6th Sense" function helps to maintain optimal conditions to storage of food and is automatically activated when: • a large amount of food is loaded into the freezer; • the freezer door is left open for a long time; • a prolonged power failure takes place, causing the internal temperature of the appliance to increase to values that cannot guarantee safe storage of food. OTHER ABNORMAL APPLIANCE OPERATIONS DISPLAYED BY LAMPS Printed in Poland 06/09 In case of abnormal appliance operation, all the temperature selection lamps will flash and a beep will sound. After pressing the Stop alarm / Stand-by mode button reset alarm , the beep will stop and the lamps will blink. To check the code alarm user have to press and hold the Temperature setting & Stand-by pushbuttons and alarm code will be showing on the temperature lamps (possible alarm codes are explained in the table below). When this operation is released, the lamps will flash until the fault is eliminated. [. . . ]